| 1. | Research on a new type instrument of axiality measuring
一种新型同轴度测量仪的研究 |
| 2. | Measure coaxiality of tow holes with three - coordinates machine
利用三座标测量机测量止口孔的同轴度 |
| 3. | Concentricity analysis of hole throats on both ends of carrier roller
托辊管体两端孔颈的同轴度分析 |
| 4. | Precise measuring for error of tooth form of involute spur gear in 3d coordinate measuring machine
三坐标测量机检测同轴度误差分析 |
| 5. | The error analysis of binocular vision ranging method based on the coordinate measuring machine
三坐标测量机同轴度误差检测功能的开发 |
| 6. | On the principles of intelligent concentricity measuring instrument and the determination of its precision
同轴度智能测量仪原理及精度测定 |
| 7. | The result can be used to instruct the centering assembling process to improve the coaxial tolerance of accelerator
研究结果为加速器对中装配同轴度提高提供依据。 |
| 8. | Roller 15 is integrated casting after processing , axiality between the two ball tracks is high with good connection with supporting roller . driving is stable and can lessen abrasion of cast rubber layer of supporting roller
为整体花蓝式铸件，经加工制成，两条滚道间的同轴度高，与托辊接触良好，传动平稳，且减少托辊铸胶层的磨损。 |
| 9. | During adjusting beam paths , the co - beam , a combination of the measuring beam and the reference beam , is not restricted to being perpendicu lar to the light sensitive surface of the object , but keeping the measuring beam and the reference beam co - axial proved to be crucial
在光路调整中，它对测量光与参考光的合光光束是否垂直于探测器光敏面要求不高，但对两光束合光同轴度则有严格要求。 |
| 10. | In view of the high demand on the coaxial tolerance of linear induction accelerator in centering assembling and considering the interaction among flange , bolts and gasket , finite element analysis was adopted and a 3 - d finite element model of accelerator in centering assembling with bolted - flange connection was built
摘要针对直线感应加速器对中装配同轴度要求高的特点，考虑法兰、螺栓和密封垫相互作用，建立了加速器对中装配法兰螺栓联接的三维有限元模型，分析了螺栓预紧力对加速器对中装配时同轴度的影响作用。 |
