| 1. | The valve realizes discharging using trimming moment 锥形锁风阀利用力矩平衡的方法实现卸灰。 |
| 2. | The automatic control of jigging air - valve based on expert system 基于专家系统的跳汰机风阀自动控制 |
| 3. | Over loading protection for the solid state relay of wind valve controller 风阀控制器中固态继电器的过载保护 |
| 4. | Reform of the air valve of jig 跳汰机风阀的改造 |
| 5. | Abstract : this paper introduces the principle of a kind of jigelectromagnetic valve , gives out hardware and software 文摘:介绍了一种跳汰机电磁风阀控制器的原理,给出了相应的硬件和软件的组成。 |
| 6. | Currently , the degrees of valves only need fine - tuning in the sites in order that the flux in the duct can be regulated to the design range 现场调试时,在正常情况下,只需微调各种风阀的开度,即可使各管段的实际流量调至设计范围之内。 |
| 7. | Compared with the test result in a pilot scale baum jig , it proved to be reasonable that the method of dealing with the relation between the water motion and the characteristics curve of air valve 与半工业性跳汰机内的实测结果进行的比较表明,所采用对跳汰机内水流运动与风阀特性的关系处理是合理的。 |
| 8. | The effect of valves to duct system is more take into account than in other design software . the thesis has also introduces the process of how to get the final degree result 这一功能的实现,源于软件充分地考虑到了风阀的实际开度对于风系统系统压力分布的相当大的影响,而这一点,很多设计软件所没有考虑到。 |
| 9. | This paper analyzes the failure in detail , discusses the theory of emcs , the communication of intelligent low - pressure and the control theory of wind valve , and attempts a solution to the malfunction 对发现的问题及故障原因进行了详细分析,讨论了机电设备控制系统与智能低压的通讯、风阀的控制原理,提出了解决方案。 |
| 10. | Experiments have failed in the process of debugging station fire mode of the first opening segment of guangzhou metro line 3 , the main reason is the delay protect module of wind valve which cut off power supply 摘要广州地铁3号线首通段车站火灾模式调试过程中,出现火灾模式执行失败,主要原因在于风阀延时保护模块动作切断电源。 |