| 1. | Heating the oil produces changes in the index of refraction of the oil , making the cell boundaries visible
取暖油产生变化，在折射率的油，使细胞界限明显。 |
| 2. | And the sm ( cocufezr ) z thin films with lower magnetocrystalline anisotropy constant of cell boundary phase will have a higher coercivity
而较低的胞壁相磁晶各向异性常数k1 ,则有助于获得高的钉扎场。 |
| 3. | Simple cuboidal epithelium lining a tubule ( longitudinal cut ) . some of the cell boundaries between " blocks " or " cubes " here are quite distinct
管腔纵切面：单层立方上皮衬于管腔内。一些立方细胞之间的边界相当清晰明显。 |
| 4. | The table toolbar contains buttons for the main table commands , including an eraser button that you can use to remove cell boundaries from the table
“表格”工具栏包含主要表格命令的按钮，其中有一个橡皮擦按钮，可用该工具擦除表格中单元格的边框。 |
| 5. | The velocity of the grid cell boundary was added into the governing equations and no source term appeared because the reference coordinate system was the inertial one
流动计算采用惯性坐标系作为参考系，这样控制方程没有出现由坐标系旋转带来的源项。 |
| 6. | In addition to the requirement for shared ltpa encryption keys , the cell level server identities end up with substantial authority across the cell boundaries
除了满足共享ltpa加密密钥的要求外，计算单元级别的服务器标识最终会导致存在大量跨计算单元边界的权限。 |
| 7. | Based on the micromagnetic model of the sm ( cocufezr ) z thin films presented in this thesis , the pining field has been computed with different physical parameters of the cell boundary phase
本文首先建立了sm ( co , cu , fe , zr ) z薄膜畴壁钉扎的二维微磁学模型,研究了胞壁相的厚度和磁晶各向异性常数对畴壁钉扎的影响。 |
| 8. | The results show that the pining field increases with the increasing of the thickness of the cell boundary phase and decrease with the further increasing of the thickness of the cell boundary phase . then high pinning field can be obtained with the appropriate thickness of the cell boundary phase
计算结果表明,随着胞壁相厚度的增加,薄膜的钉扎场先增加后降低,这说明胞壁相厚度与畴壁宽度相当时才会获得较大的钉扎。 |
| 9. | In these regions , an expensive high - order accurate eno scheme is applied to evaluate the numerical flux at cell boundaries . and hi smooth regions a cheap spline interpolation is used to get the value of the numerical divergence from values previously obtained on lower resolution scales to save the computational cost
在这些奇性区域，我们利用代价昂贵的高阶基本无振荡格式计算单元边界的数值通量；而在解光滑的区域，则用廉价的样条插值根据先前低分辨尺度上得到的值来计算出其数值散度，从而减少计算工作量。 |
