| 1. | Lastly , several conclusions on bad data detection and identification for distribution system are given
最后，得到了配电网络不良数据检测与辨识的若干结论。 |
| 2. | Abstract the problem about bad data detection and identification in distribution system state estimation is focused in this thesis
本文着重分析了配电网状态估计中的不良数据检测与辨识的问题。 |
| 3. | Present status of the distribution system state estimation , and methods of bad data detection and identification are surveyed here
并对配电网状态估计的研究现状和常用不良数据的检测与辨识方法进行了描述。 |
| 4. | Slave computers have data detection and control function with the help of the data capture and control interfaces which are composed of all kinds of position switches , sensors and execution units
以各种位置开关、传感器和执行元件为电站的数据采集和控制的接口，下位机具有数据检测和控制功能。 |
| 5. | At last , this dissertation present an algorithm that performs joint frequency offset acquisition , channel estimation and data detection for each active user . users ’ separation is accomplished at the base station through space - alternating generalized - expectation ( sage ) techniques
最后本文给出了一种可以对每个用户进行载波频偏获取、信道估计和数据侦测的盲信道同步算法,并借助于sage算法在基站( bs )对用户信号进行分离。 |
| 6. | The automation is composed of two operating station computers ( one is a backup computer ) and three slave computers . every slave computer , which is cored by omron c200 plc , controls a generator independently . slave computers have data detection and control function with the help of the data detection and control interfaces which are composed of all kinds of position swiches , sensors and execution units
本自动化系统由两个主站(其中一个是备用站)和三个子站组成，每个子站由一台omronc200hplc构成，独立控制一台发电机。 |
| 7. | Second , the transmission and reception models of basedband cdma system based on complete complementary codes in up - and downlink are discussed and its performance in awgn channel is analyzed and evaluated through simulation . third , a receiver for multipath signal reception is investigated , which consists of two matched filters : one for channel impulse response estimation and the other for data detection
接下来，对基于完全互补码的基带cdma系统上行链路和下行链路发送与接收模型进行了讨论，分析了该系统下行链路在awgn信道中的系统性能，并对该系统上行链路和下行链路在awgn信道中进行了仿真。 |
