| 1. | The source address is pushed onto the stack 将源地址推送到堆栈上。 |
| 2. | Of bytes from a source address of type )从源地址(类型为 |
| 3. | Copies a specified number bytes from a source address to a destination address 将指定数目的字节从源地址复制到目标地址。 |
| 4. | To configure dynamic inside source address translation , perform the tasks in figure 执行图当中的步骤,可以进行动态内部起始地址转换的组态设定。 |
| 5. | To configure static inside source address translation , perform the tasks in figures and 执行图1和图2当中的步骤,可以进行静态内部起始地址转换的组态工作。 |
| 6. | The information available is the source address , the source port , the destination address , and the destination port 可得到的信息为:源地址,源端口,目的地址,目的端口。 |
| 7. | The third command specifies that this rule will match any packets not from source address 203 . 16 . 1 . 89 第三条命令指定该规则将与除来自源地址203 . 16 . 1 . 89外的任何信息包匹配。 |
| 8. | This is typically caused by a router forwarding a packet using an interface that is outside the scope of the source address 这通常是由于路由器使用了源地址范围以外的接口转发数据包所导致的。 |
| 9. | The above example shows destination address specifics with the - d , but is identical for source addresses with - s , instead 上面的例子展示了目的地址的细节(用- d ) ,但和源地址的用法是相同的(只是代之以- s ) 。 |
| 10. | Use an ingress filter on your network to ensure that no packets enter your outside boundary with a source address of your internal network 在网络中使用入口过滤器来确保没有使用你的内部网络的源地址的包进入你的外界。 |