| 1. | Intermontane basins in relatively stable regions subjected to regional uplift .
较稳定区域内的山间盆地，曾有过区域隆起。 |
| 2. | Connection among four progressive lines for stable region of atomic nucleus
四条核素递变线间的联系 |
| 3. | In some stable region , the procedure was found to converge fast
由研究分析结果可知在某些稳定条件下的收敛速度较快。 |
| 4. | Analysis of bifurcation and stable region for water turbine generator shaft torsional vibrations
大型水轮发电机组轴系扭振的分岔和稳定域分析 |
| 5. | A numerical method on estimation of stable regions of rotor systems supported on lubricated bearings
滑动轴承转子系统动力学稳定域的数值分析方法 |
| 6. | Some conditions are obtained by using the semigroup theory , the properties of nonnegative matrices and the techniques of inequalities to determine the asymptotically stable region of the equilibrium
通过半群理论、非负矩阵性质和不等式技巧，得到估计这类方程平衡态渐近稳定域的方法。 |
| 7. | Adopting current feedback suspension control algorithm , the stable region of control parameters are narrow , overshoot is great and unable to make the closed - loop system bandwidth narrow
目前采用的基于电流反馈的悬浮控制算法,参数稳定范围小、超调量大,且无法将闭环系统带宽设计得较低。 |
| 8. | Finally , single magnet and bogie suspension experiments have been carried out . also two kinds of control algorithms effect has been compared . the experiments confirmed that flux feedback control has a wide parameter stable region and satisfying dynamic performance
最后,进行了单铁及转向架的悬浮实验,比较了两种控制算法的实际效果,实验验证了磁通反馈参数稳定范围大、动态性能好的控制效果。 |
| 9. | Compare the experiment data with the theoretic stable region and confirm that the biped walking robot as leg mechanism has good stability of static walking , and provide theoretic and data information for further work
并对影响步行机器人稳定性能的参数进行分析，将得到的数据与理论上的稳定区域相比较，可以确定本文设计的步行机器人腿机构有很好的静态行走稳定性，为下一步的工作提供了理论及数据依据。 |
| 10. | The analog pd and pid controller are studied . the application of lqr optimal control theory on the controller design is discussed , and pid with nonlinear regulator has been applied to control the system with high system stiffness and large stable regions
研究了几种模拟控制器，应用线性二次型最优控制理论设计了线性调节器，并研究了带非线性引前校正环节的pid控制器，提出了大幅度提高系统刚度和稳定范围的参数设计方法。 |
