English translation for "下轴"

bottom spindle
lower shaft

Example Sentences:

	1.	Upper axles tower , seat of lower axle ) 里程表机芯（上轴座、下轴座）
	2.	Specialize in connector press pieces of factory devoted to connector , connector become always , golden cup lay axle , shock absorber , rubber press production and processing of one 专业生产连接器冲压件厂一直致力于连接器、连接器总成、金杯下轴、减震器、橡胶冲压件的生产和加工。
	3.	After crushed and granulated , they ll pass through the vibration sieve to be graded , and granules which meet requirement can be obtained . powder after the sieve will return to the vibrastion hopper to be granulated circularly 料片落入破碎整粒机整粒后进入振动筛过筛分级，得到符合要求的颗粒产品，筛下轴粉返回振动料斗循环制粒。
	4.	Aimed at the working characteristics of axial parts under high temperature and vacuum environment , this paper put forward a temperature controlling method for changing the partial thermal resistance of axial under the stable uneven temperature field 摘要针对高温真空环境下轴类零件的工作特点，提出了在稳定非均匀温度场下改变轴局部热阻的控温方法。
	5.	Turning the oil amount adjustment screw attached on the hook driving shaft front bushing in the “ + ” direction ( in direction a ) will increase the amount of oil ( oil spots ) in the hook , or in the “ ? ” direction ( in direction b ) will decrease it 把下轴前端金属部件上的油量调详螺丝向的方向（ a方向）转动，油量变多，向的方向（ b方向）转动，油量变少。
	6.	By analysing testing data , we do a study of relations between lateral swelling strain and water content , between lateral swelling strain and axial loading , and between swelling pressure and water content . 4 通过试验资料整理分析，深入探讨了膨胀岩的侧向约束下轴向膨胀变形与含水率之间的关系、轴向膨胀变形与轴向荷载之间关系以及不同始末状态膨胀压力发展规律。
	7.	In chapter 4 , the modified reynolds equation is solved numerically with the finite different method , and the generated axial thrust force , minimal mucus film thickness , load capacity of hydrodynamic pressure and circumferential friction under the serrate screw are obtained . at last , using numeral methods and coordinate graphs , the influences of serrate screw parameters on the generated axial thrust force , minimal mucus film thickness , load capacity of hydrodynamic pressure and circumferential friction are studied and analyzed 第四章，首先求出锯齿形螺纹下数值计算所需的有限差分方程，再推出了锯齿形螺纹作用下轴向摩擦牵引力、粘液膜厚度、粘液膜承载能力、周向摩擦阻力无量纲表达式，最后用数值计算方法求解，通过坐标图分析了锯齿形螺纹参数对轴向摩擦牵引力、最小粘液膜厚度、粘液膜承载能力、周向摩擦阻力的影响。
	8.	The influence of the eccentricity mass moment , position of mass center and the bearing stiffness to the vibration characteristics of the rotor system is discussed in detail ; 3 . to verify the exactness of fem and learn the principle of vibration of dredge pump further , the orbit of the rotor shaft of the pump in the dredger is measured , the measurement results show : the repeat of the orbit of the rotor shaft is very bad when dredge pump is in the dredging mud condition 模态分析确定了泥泵的振动特性(固有频率和振型) ；谐响应分析确定了泥泵转子轴在偏心力的作用下轴截面处的最大响应位移；研究了转子轴的质心位置、轴承刚度和质量偏心矩对转子轴振动特性的影响； 3 、采用轴心轨迹法，实船测量了泥泵轴工作时振动响应值。
	9.	In chapter 2 , an accurate modified reynolds equation is derived . the modified reynolds equation is solved numerically with the finite different method , the generated axial thrust force , minimal mucus film thickness , load capacity of hydrodynamic pressure and circumferential friction under the rectangular screw are obtained . at last , using numeral methods and coordinate graphs , the influences of rectangular screw parameters on the generated axial thrust force , minimal mucus film thickness , load capacity of hydrodynamic pressure and circumferential friction are studied and analyzed 第二章，首先推导了非牛顿流体的变形雷诺方程，化简了雷诺方程，得出了矩形螺纹下有限差分方程；还推出了矩形螺纹作用下轴向摩擦牵引力、粘液膜厚度、粘液膜承载能力、周向摩擦阻力无量纲表达式，最后用数值计算方法求解，通过坐标图分析了矩形螺纹参数对轴向摩擦牵引力、最小粘液膜厚度、粘液膜承载能力、周向摩擦阻力的影响。
	10.	In chapter 3 , the modified reynolds equation is solved numerically with the finite different method , and the generated axial thrust force , minimal mucus film thickness , load capacity of hydrodynamic pressure and circumferential friction under the trapezoidal screw are obtained . at last , using numeral methods and coordinate graphs , the influences of trapezoidal screw parameters on the generated axial thrust force , minimal mucus film thickness , load capacity of hydrodynamic pressure and circumferential friction are studied and analyzed 第三章，首先求出梯形螺纹下有限差分方程，然后推导了梯形螺纹作用下轴向摩擦牵引力、粘液膜厚度、粘液膜承载能力、周向摩擦阻力无量纲表达式，并用数值计算方法求解，通过坐标图分析了梯形螺纹参数对轴向摩擦牵引力、最小粘液膜厚度、粘液膜承载能力、周向摩擦阻力的影响。

Similar Words：

"下周一" English translation, "下周一面试" English translation, "下周一我得作半年度报告" English translation, "下周荧屏" English translation, "下周再查查吧" English translation, "下轴承" English translation, "下轴承盖" English translation, "下轴承架" English translation, "下轴承箱" English translation, "下轴承箱盖" English translation