| 1. | In - wall temperature measure of the closed - bomb
爆发器内壁温度的测试 |
| 2. | The study of an indirect method measuring inside - wall temperature of gun tube
膛内壁温度间接测量方法研究 |
| 3. | Effect of pipe wall and crude oil temperature on wax deposition in pipeline transportation
输油管道系统管壁温度与原油温度对蜡沉积的影响 |
| 4. | The conclusions are helpful for calculation of inner surface temperature in practice
结论对于实际工程中准确确定内壁温度有一定的指导作用。 |
| 5. | The circuit metal temperature is an elemental result averaged over the cycle , and shows the temperature of the metal cooling circuits
冷却管壁温度?基于元素的结果，冷却管金属壁在整个循环中的平均温度。 |
| 6. | If electric heating pipes are put into operation firstly , preheat the pipes to the maintenance temperature of media , then open valve
电伴热管线首次投运介质前，应先预热管道，使管壁温度达到介质维持温度后，再开启阀门。 |
| 7. | The inner surface temperature , when there are defects in the wall or air convective heat transfer and radiation are referred , is studied respectively
分别分析了壁内存在缺陷，考虑缺陷内的空气对流换热及表面辐射对反推内壁温度的影响。 |
| 8. | A one - dimensional simplified model on the inner surface temperature computation conversely based on the outer surface temperature measured by infrared imager was presented
摘要利用红外热像仪获得外壁温度，在简化的一维模型下反推内壁温度。 |
| 9. | It is given that quantitative diagnosis to estimation errors of internal temperature of a hot wire embedded at the center of a cylinder - shaped heat equipment
摘要对采用红外监测反推法，由加热圆柱外壁温度，确定圆柱体内壁温度的误差进行了量化分析。 |
| 10. | The methods of optimization are developed for the quantitative diagnosis by solving an inverse heat condition problem based on infrared temperature - measuring
在分析的基础上，给出了影响圆柱体内壁温度测量的主要因素，提出了优化加热柱体内壁温度测量的途径。 |
