| 1. | The thought of establishing mechanical vibrating model
关于建立机械振动模型的思考 |
| 2. | The method of forming small damage fem in ansys
如何高效建立小损伤振动模型 |
| 3. | Almost periodic solution and periodic solution for an autocatalytic oscillatory model
一个自催化振动模型的概周期解与周期解 |
| 4. | After the calculation of transverse - distributing load , the vibration model of bridge is established
以关于梁桥荷载横向分布计算为基础，建立桥梁的振动模型。 |
| 5. | Various numerical methods are used to solve the structure models , such as fourth order rounge - kutta method and lax method
在固体区域针对不同的固体振动模型采用了四阶rounge - kutta法或lax法求解。 |
| 6. | Based on a jeffcott rotor system with rigid support , the differential equations of coupled vibrations are established
针对存在质量偏心的单圆盘jeffcott转子模型，通过拉格朗日方程，建立了弯扭耦合振动模型。 |
| 7. | On the basis of cutting force model and vibration model of machine tools structure , the effect of the regenerative chatter on the stability of end milling is focused
存得到切削力模型和机床结构振动模型的基础上，着重研究了再生型颤振对铣削加工过程稳定性的影响。 |
| 8. | Secondly , introduce the three main errors : quantization error 、 the gear error and the abnormal point . thirdly , we use the model of vertical vibrations to design the radii method
3 .利用轮胎垂直方向的振动模型设计了半径法tpms ,利用了汽车防抱死系统( abs )系统原有的硬件。 |
| 9. | By using the model analysis method and hammer test , the model parameters and model shapes are obtained based on the force and response signal processing
本文利用试验模态分析技术，通过冲击锤激振试验，对激振力信号和响应信号处理的基础上，获得机床结构的模态参数和振动模型。 |
| 10. | Impedance of aluminium beam is tested with pzt and studied impedance frequency specialty , and the real impedance , the stain mode and position of pzt are analyzed
实验将铝梁作为测试对象，在其上粘贴压电陶瓷，通过对阻抗应答、振动模型和压电陶瓷片的粘贴位置的分析，研究梁的阻抗频率特性。 |
