| 1. | Bonding interface - the area where the bonding of two wafers occurs
绑定面-两个晶圆片结合的接触区。 |
| 2. | Circular tooth contact
齿面接触区 |
| 3. | Computer aided analysis for contact pattern of prolate epicycloid bevel and hypoid gears
摆线齿锥齿轮齿面接触区的计算机辅助分析 |
| 4. | According to the study , the contact region between the twist - roller and the shaft is an ellipse
研究表明，扭轮和传动轴接触区形状为一椭圆。 |
| 5. | Study on mesh theory of roller oscillating tooth gear drive and numerical value simulation of tooth profile contact area
滚柱活齿传动的啮合理论及齿廓接触区数值仿真 |
| 6. | Uninterruptible power systems - general and safety requirements for ups used in operator access areas
不间断电源系统ups在操作人员接触区内使用的ups的通用和安全要求 |
| 7. | The package is not only used for computer aided analysis tooth contact pattern , but also for analyzing the moving rule of tooth contact pattern
本软件不仅可用于切齿调整的计算机辅助分析，而且可用于齿面接触区移动规律的计算机辅助分析。 |
| 8. | Running through the developed calculation software package , the diagram output by computer softwares closely coincides with the contact pattern observed on a testing machine
利用研制成的“齿面接触分析”软件对一实例进行计算，计算机输出的图形与切齿实验得到的接触区基本相同。 |
| 9. | However , the increasing trends of wear depth varies at different fretting wear conditions due to the simultaneous variations of contact area and contact stress in the process of fretting wear
建立的钢丝接触有限元模型表明，接触区中心的最大接触应力随着接触载荷的增加而增大，随着嵌入深度的加深而减小。 |
| 10. | The results indicate that the boundary conditions have negligible effect on indent depth estimate , and the stiffness of laminates in contacting area has the major effect on the indent depth
结果表明,不同边界条件下相同压痕力对应的压痕深度几乎相同,边界条件对压痕的影响微乎其微,板的压痕更主要取决于接触区板的局部刚度。 |
