| 1. | The greatest stress is found at the location on the cross section where v is the largest .
最大应力出现在横截面上V为最大的地方。 |
| 2. | Either the maximum and minimum stresses of one of these and the mean stress-are required to specify the fluctuation .
需要两个值：最大应力和最小应力或二者之一和平均应力，以确定其起伏程度。 |
| 3. | Maximum stress theory
最大应力理论 |
| 4. | The greatest stress is found at the location on the cross section where v is the largest
最大应力出现在横截面上v为最大的地方。 |
| 5. | The maximum stress was on the apices and the stress on the cervical part was lower
种植体应力主要为均匀分布的压应力，最大应力位于种植体根尖部，颈部应力相对较小，未见明显弯曲应力。 |
| 6. | The results are that the maximum displacement and maximum stress occurs at initial time and the maximum stress is less than permissible stress
结果表明,结构最大应力和最大位移均发生在初始时刻,最大应力小于许用应力。 |
| 7. | By analyzing the optimal diffluent ratio and solder angle of the dies , the maximum stress in the body of improved dies is de - creased effectively
对模具的分流比和焊合角进行优化并再次模拟，发现分流模的最大应力大大降低。 |
| 8. | The results show that the shrinking and maximum temperature stresses correspond to 1 / 3 and 1 / 5 of the total strut axial forces respectively
结果表明，收缩引起的应力相当于整个支撑轴力的1 / 3 ，而温度变化引起的最大应力相当于支撑轴力的1 / 5 。 |
| 9. | The stress of horizontal working states is bigger than others , and the maximum stress attaches to 540 mpa . only considering static strength , the bump auto satisfies command
水平工况应力较大，最大应力为540mpa ，单从静强度方面考虑，该泵车满足强度要求。 |
| 10. | Therefore , this design makes material sufficiently used , the weight of road wheel effectively lightened . at the same time , stress distribution is more reasonable
结果表明：最大应力值接近铝合金车轮的强度极限，充分利用了材料，有效的减轻了重量，应力分布更加合理。 |
