Mobile
Log In Sign Up
Home > english-chinese > "误差放大器" in Chinese

Chinese translation for "误差放大器"

error amplifier
vea


Related Translations:
误差:  error 短语和例子平均误差 mean error; average error; 仪器误差 instrumental error; 概然误差 probable error; 行星观测上位置与计算上位置间的误差 the error of a planet; 误差极微的精密零件 precision parts with very close tolerances; 误差不超
检波器放大器:  detector amplifier
射流放大器:  fluid amplifierfluid amplifiterfluidic amplifierjet amplifier
铁氧体放大器:  ferrator
耦合放大器:  coupling amplifier
检验放大器:  check amplifier
生物放大器:  biological amplifier
膜片放大器:  diaphragm amplifier
超载放大器:  overdriven amplifier
载波放大器:  carrier ampliffiercarrier amplifier
Example Sentences:
1.Connected to the other input of the error amp is the midpoint of a voltage divider . we ' ll come back to this later
连接误差放大器另一个输入点的是一个电压分压器的中点电压。稍后我们再来讨论。
2.The large c1 cap rolls off the gain of the regulator starting at a low frequency so that high frequency noise isn ' t amplified by the error amp
这个大的电容c1从一个较低的转折频率开始滚降,所以高频噪音没有被误差放大器放大。
3.In new system the error pa can also amplify the original signal , so the performance of whole amplifier system increases . since rf predistorters used in the new system , the linearity and power efficiency can be enhanced
该技术改变了误差通路中的信号特性,使误差放大器也输出有用信号功率,提高了整个放大系统的性能。
4.In order to design the parameter of error amplifier , the small signal model is derived for arc welding inverter using state - space averaging , and frequency - domain analysis is performed to complete the parameter design
为了设计控制系统中误差放大器的参数,利用状态空间平均法建立了电源系统的低频小信号数学模型,进而利用控制理论中的频域分析法设计了系统的补偿网络,即误差放大器的参数。
5.The whole circuit consists of a multiplier , an error amplifier , a comparator , a rs flip - flop , an and gate , and an inverter , etc . . the electronic circuit simulator cadence is utilized to practice the detailed functional simulation of the general circuit and the subsystem circuits
整个电路由模拟乘法器、误差放大器、比较器、 rs触发器、与门和倒相器等基本单元电路组成,采用工作站上的大型ic设计软件cadence进行仿真。
6.Battery is the only power source for portable equipment . in order to prolong the service time of these battery - operated equipments , ultra - low - power consumption is demanded . the main method that decreases the power losses is to higher the conversion efficiency and to lower the operating voltage
开关变换器内包含了带隙参考电压源、误差放大器、频率补偿电路、三角波产生电路、 pwm比较器以及数字逻辑控制电路,此芯片采用联华电子公司0 . 6微米cmos工艺。
7.Some sub - block circuits ( error amplifier , soft - start , enable comparator and under - voltage protection circuit ) are designed and several electrical characteristics are simulated using hspice . finally , the whole chip performance is simulated . and the results show the satisfaction to both function targets and characteristics
在子电路设计中,本论文只对其中的误差放大器、软启动电路、使能比较器和欠压保护四个子电路进行了电路原理分析与设计,并在此基础上,运用eda软件hspice对各功能模块的各项指标、参数进行了仿真、分析。
8.In the diagram , the output of the error amp is connected to the base of an npn transistor : when the error amp drives current into this transistor ' s base , it allows current to flow from collector to emitter , and that transistor in turn pulls current from the base of the pass transistor
在这个图里,误差放大器的输出端连接到了一个npn三极管的基极上:当误差放大器输出电流到了三极管的基极上,三极管允许电流从集电极向发射极流动,这个传输三极管工作时就是就是从基极吸取电流的过程。
9.In the thesis , some of the most important functional modules of the pwm power control ics are designed and simulated , including error amplifier , voltage reference , voltage regulator , comparator , and oscillator . the topologies , schematics and layouts of some circuits are introduced and developed
本毕业设计研究和提出了构成pwm电源控制芯片的主要功能模块,设计了其中主要模块ip核的多种结构电路并进行了仿真,完成了部分电路的版图设计? ?包括误差放大器,基准电压源,电压调节器,比较器,振荡器等。
10.The synchronous rectifying and low power sampling technology is used to reduce the power consumption , flexible external loop compensation , error amplifier output clamp are adopted for better system large signal response . the piecewise slope compensation technology is employed to minimize the consequence of over compensation . the sensor resistor is externally connected , which realize output voltage programmable . the overheat protection and under voltage protection modules are integrated in the die to allow the reliable operation of the system
同时,电路设计采用同步整流技术、低功耗电流采样技术降低功耗,提高转换效率;采用灵活的外部环路补偿技术、误差放大器输出嵌位技术以实现良好大信号特性;采用分段斜坡补偿技术,消除不稳定因素,并最大程度地减小过补偿带来的问题;采用外接输出采样电阻的方式,实现输出电压的可编程。
Similar Words:
"误差方程式" Chinese translation, "误差方向" Chinese translation, "误差方向, 失配方向" Chinese translation, "误差防护" Chinese translation, "误差放大" Chinese translation, "误差放大因子" Chinese translation, "误差分布" Chinese translation, "误差分布律" Chinese translation, "误差分布码" Chinese translation, "误差分布原理" Chinese translation