| 1. | Effect of temperature of coagulation bath on structure and properties of lyocell fibers from bamboo pulp
凝固浴温度对有机溶剂法再生竹纤维素纤维结构与性能的影响 |
| 2. | Effects of coagulation bath temperature on the structure and performance of polyethersulfone hollow - fiber membranes by dry wet process
凝固浴温度对相转化聚醚砜中空纤维膜结构与性能的影响 |
| 3. | 4 . the effect of the temperature and concentration of the second coagulation bath on the structure and properties of pes membranes are studied
4 .研究了第二凝固浴温度和浓度对聚醚矾膜的结构与性能的影响。 |
| 4. | 3 . the effects of the component and the time in the first coagulation bath on the structure and " properties of pes membranes are studied
3 .研究了第一凝固浴的组分和第一凝固浴中的停留时间对膜表层结构与膜性能的影响。 |
| 5. | In the case of high nmmo concentration of coagulation bath , the pure water flux is higher while the rejection can be kept at a relative high value
而改变凝固浴中nmmo的浓度则可制得高通量、高截留率、高应用价值的分离膜。 |
| 6. | As the time in the first coagulation bath increases , the water flux decreases and the clearance rates of urea and creatintine both first increase , then decrease and increase a little at last
随着在第一凝固浴中停留的时间越长，膜的水通量越低，肌肝和尿素的去除率均是先升高后下降然后稍有上升的趋势。 |
| 7. | The effects of polymer concentration , solvent volatilization time , temperature and composition of coagulation bath and the thickness of membranes are studied for preparing the best nanofiltration membrane
实验重点考察了铸膜液固含量、溶剂蒸发时间、凝胶浴组成和温度、膜厚等因素对所制纳滤膜性能的影响。 |
| 8. | As the temperature of the second coagulation bath increases , the water flux increases and the clearance rates of urea and creatintine first increase then decrease and increase a little at last
随着第二凝固浴温度的上升，水通量一直上升，肌肝和尿素的去除率先是上升，然后下降，最后又有略微上升的趋势。 |
| 9. | With a decreasing cellulose concentration of casting solution or an increasing temperature of coagulation bath , the mean pore ssze becomes larger , resulting in higher pure water flux and lower rejection of bsa
随着铸膜液浓度的降低或凝固浴(纯水)温度的升高，膜的水通量有较大的提高，但截留率会明显下降。 |
| 10. | The results showed that when the nmmo concentration of coagulation bath is 20 % , the temperature is 25 and the cotton pulp concentration is 5 % , cellulose packaging films with the excellent mechanical properties can be prepared
结果表明，棉浆浓度为5 % ，凝固浴浓度为20 % ，凝固浴温度为25时，可制得有较好力学性能的纤维素包装膜。 |
