| 1. | In - wall temperature measure of the closed - bomb
爆发器内壁温度的测试 |
| 2. | The study of an indirect method measuring inside - wall temperature of gun tube
膛内壁温度间接测量方法研究 |
| 3. | Adiabatic wall temperature
绝热壁温 |
| 4. | The infrared radiation and wall temperature were obviously decreased by cooling
通过冷却，各喷管的壁温和红外辐射强度明显降低。 |
| 5. | It is suggested to use on - line monitoring facility to measure inner farnace wall temperature , ensuring safe operation of the boiler
建议采用炉内壁温在线监测装置，以保证锅炉的安全运行。 |
| 6. | Elevating the temperature of the cooling water or reducing the wall temperature before water quenching can prevent walls from yielding effectively
提高冷却水温度或降低进水冷焦前塔体温度能有效防止塔体产生塑性变形。 |
| 7. | In the experiment , the infrared radiation and axial distribution of wall temperature and near wall flow pressure were measured with and without film cooling
得到了各冷却方案喷管的壁面压力分布、壁温分布和红外辐射特性。 |
| 8. | Wall temperature had a remarkable effect on smog exit temperature , whereas its effect on other parameters was not obvious
壁面温度对最高燃烧温度、壁面最大热流和平均热流影响不明显，但烟气出口温度随壁面温度的升高而增加较大。 |
| 9. | Based on this model , wall temperature of spiral finned tubes has been computed to verify the validity of the model put forward in the paper
建立了螺旋肋片管低温再热器的壁温计算数学物理模型，并对螺旋肋片管低温再热器进行了壁温计算。 |
| 10. | By increasing the wall temperature , the temperature difference reduced . the greater the temperature differences , the larger of the concentration of the 2 - micron particle
冷却面温度变化时，壁面与主流区的温度差越大， 2微米颗粒在壁面处的浓度越高，浓度升高由温度差引起。 |
