Chinese translation for "光耦"

el817
optocoupler
pc817
tlp521

Related Translations:

耦:  Ⅰ动词[书面语] (两人并耕) plough side by sideⅡ名词1.(古农具名) plough2.[书面语] (两人一组) a team of two3.(双数) pair; couple; even4.(配偶) mate; spouse5.(姓氏) a surname 短语和例子耦嘉 ou jia

耦嘉:  ou jia

耦园:  the couple’s garden retreat

退耦:  decoupledecoupling

末耦:  suetomo

电耦联:  electrical coupling

解耦面:  decoupling level

去耦电路:  decouplerdecoupling circuitisolation circuit

自耦启动器:  autotransformer starter

离子耦联:  ionic coupling

Example Sentences:

	1.	Input mode : optically - isolated input 24 12vdc 输入方式光耦隔离输入，直流24v 12v
	2.	Optically - isolated input : 24vdc 光耦隔离输入直流24v
	3.	Principle and experimental research into 4 photocoupler s isolation amplifier 四光耦线性隔离放大器原理及实验研究
	4.	The communication module comprises of can driver , photocoupler and tms320lf2407 ' s internal can controller 通信模块利用tms320lf2407内部自带的can控制器，再外接can驱动芯片pca82c250和高速光耦6n137构成。
	5.	Finally designs the interface cirvuit with the master control system . the analog singal is isolated by linear optical isolator and the digital signal is isolated by common optical isolator 设计了与主控系统的接口隔离电路,采用线性光耦对模拟信号进行隔离,普通光耦对数字信号进行隔离。
	6.	This paper introduces some ways based on the linear analog light - coupler to measure the voltage of single battery in the series - wound vehicle ni - mh battery , and designs a battery management hardware system and practical voltage measurement circuit 本文设计了一种电池管理硬件系统，并介绍几种基于隔离光耦的电压测量电路，设计出一种实用的测量电路。
	7.	The programs of system are written with assemble language . in order to resolve the problem of signal jammed , not only we used hardware ( photo couplers , watchdog , special parts , etc . ) , but also used some arithmetic ( average , wavelet , etc . ) . after analyzing the deficiency of the popular mechanical instrument in motorcycle , this paper focuses on researching and designing the digital instrument . the developing work of ( the research of the led digital multi - parameters instrument in motorcycle ) has been finished and is being commercializing packaged 我们采用了专用的a / d转换器作为模拟量的测量，采用光耦器件作为车速、发动机转速信号的输入，采用高亮度的led器件作为在强光下显示器件，采用两个独立的微处理器以提高系统的可靠性，采用模拟条和数码管同时显示以符合驾驶人员的习惯，同时通过改进算法，实时处理车速和发动机转速与数据显示和数据存储等技术难点。
	8.	This system is developed based on high performance , low cost and many controllers inside of the embedded processor , and enlarged gpio for the plat of the hardware and software . this system is applied to the high - speed numerical control carving machine . show the operate interface by lcd , input the control code from the keyboard , the data is readed from the usb interface and store that in sdram 本系统应用于高速数控雕刻机,以lcd为人机可视化操作界面,以编码键盘为操作控制部分,以嵌入式处理器s3c44b0x芯片为核心,文件数据经usb口读取u盘中的雕刻数据文件暂存于sdram中,经嵌入式处理器进行相关算法处理,得出相应参数传送到fpga ,由fpga控制输出脉冲和脉冲间延时,通过高速光耦隔离( 2mbit / s )后输出,控制步进电机的运转。

Similar Words：

"光碥读数杆" Chinese translation, "光町" Chinese translation, "光锉" Chinese translation, "光镘" Chinese translation, "光褶蛤属" Chinese translation, "光耦半导体开关" Chinese translation, "光耦合" Chinese translation, "光耦合半导体开关" Chinese translation, "光耦合半导体掐" Chinese translation, "光耦合电晶体" Chinese translation