| 1. | Cross - country skis ; ski binding screws ; requirements ; identical with iso 7794 : 1991 越野雪橇.雪橇紧固螺钉.要求 |
| 2. | 5 wring the bolt 5紧固螺钉 |
| 3. | Cross - country skis - ski binding screws test methods ; identical with iso 7795 : 1994 越野雪橇.雪橇紧固螺钉.试验方法;等同采用iso 7795 |
| 4. | Fix control units with m4 bolt on the fitting position inside distributor , and then fasten bolt 将控制组件用m4螺钉固定在分电器内侧的装配位置上,然后紧固螺钉 |
| 5. | Fix control units with m4 bolt on the fitting position inside distributor , and then fasten bolt 将控制组件用m4螺钉固定在分电器内侧的装配位置上,然后紧固螺钉; |
| 6. | Align sensor iron core with distributor timing rotor with a clearance between 0 . 25 0 . 4mm , then fasten the bolt 调整传感器铁芯正对分电器正时转子,间隙在0 . 25 0 . 4mm间,然后紧固螺钉 |
| 7. | Mechanical properties of fasteners made of carbon steel and alloy steel - part 5 : set screws and similar threaded fasteners not under tensile stresses 用碳钢和合金钢制成的紧固件的机械特性.第5部分:不低于拉伸强度的紧固螺钉和类似螺纹紧固件 |
| 8. | Install the assembly sensor on the distributor support seat assembly , regulate the clearance between sensor and rotor up to requirement , and then fasten bolt 将总成传感器安装在分电器支承座总成上,调整转子与传感器间隙符合规定后,紧固螺钉 |
| 9. | Install the assembly sensor on the distributor support seat assembly , regulate the clearance between sensor and rotor up to requirement , and then fasten bolt 将总成传感器安装在分电器支承座总成上,调整转子与传感器间隙符合规定后,紧固螺钉; |
| 10. | Install the electronic ignition control module on the shell of distributor , fasten bolt , and then put on protective cover on sensor and electronic ignition control module 将电子点火控制模块安装在分电器壳体上,紧固螺钉,然后给传感器及电子点火控制模块罩上防护罩 |