Mobile
Log In Sign Up
Home > chinese-english > "rail-to-rail" in English

English translation for "rail-to-rail"

轨至轨
线对线


Related Translations:
east rail:  东铁
rail end:  导轨末端铁轨端部
sheeting rail:  板栅横挡
rails:  床侧栏杆肋骨 或者指两桥之间板底的两个边铁路股票秧鸡科
rail voltage:  干线电压
rail:  n.1.(围栏等的)横木,横档;(钉帽架等用的)横条,栏杆,扶手;〔pl.〕围栏。2.轨道;钢轨;铁路;〔pl.〕铁路股票。短语和例子a towel rail (钉在墙上的)挂毛巾的横木。 a rail advice (铁路)到货通知单。 zero-length rail 【火箭】超短型导轨。 by rail 乘火车,用火车。 get [go] off the rails
heavy rail:  重钢轨重铁重型钢轨重型路系重型铁路系统
rail wing:  辙叉翼轨
breast rail:  船楼侧拦杆横向栏杆船楼端栏杆横向围栏桥楼横向栏杆腰栏
rail gaadjusting:  轨缝调整
Example Sentences:
1.The sgm8067 is rail - to - rail output voltage feedback amplifiers offering ease of use
Sgm8067是轨到轨输出电压反馈运算放大器。
2.The new rail - to - rail low - voltage op - amp can be applied in dvd player , sound card , cellphone , gps system and so on
这种新型的轨对轨低压运放可以用于dvd播放器、声卡、手机、 gps系统等电路。
3.The lower supply also makes the dynamic range of signal reduced . this requires the op - amp a rail - to - rail input and output stage
电源电压的降低也使得信号的动态范围极大减小,这就要求运算放大器能做到输入轨对轨和输出轨对轨。
4.Third , rail - to - rail amplifier output stages exhibit load - dependent gain which affects amplifier open - loop gain , and hence closed - loop gain accuracy
第三,轨到轨放大器输出级增益与负载有关,这将影响放大器的开环增益,当然也影响了闭环增益的准确性。
5.3 . the output stage of transimpedance amplifier is realized with rail - to - rail topology to meet the requirement of output swing of the instrumentation amplifier
3 .针对仪表放大器的输出摆幅的要求,在跨阻放大器的输出级采用rail - to - rail结构来实现。
6.In this thesis , analysed and designed the architecture of the new type cmos rail - to - rail operational amplifiers in detail , and successfully designed one of two stage compact cmos rail - to - rail amplifier and the cmos bandgap reference current source
本次论文详尽地分析和研究了新型cmosrail - to - rail运算放大器的结构,完成了两级压缩式cmosrail - to - rail运算放大器和cmos带隙参考电流源电路的设计。
7.In order to expand the signal the dynamirange , the low voltage operational amplifier usually needs the input signal scope and the output signal scope to be able to achieve the entire amplitude , in view of this question , this article discusses as follows : one is designed with ab rail - to - rail output stage
为了扩大信号的动态范围,低电压运放通常需要输入输出的信号范围能达到全摆幅。针对这个问题,本文做了如下工作: 1 )设计了一个是包含ab类轨对轨输出级的低功耗运算放大器。
8.The thesis has done the widespread investigation and study to the domestic and foreign ’ s technologies of analogy low voltage and low power , and analyzes the principles of work , merts and shortcomings of these technologies , based on the absorption of these technologies , it designs a 1 . 5v low power rail - to - rail cmos operational amplifier . when designing input stage , in order to enable the input common mode voltage range to achieve rail - to - rail , it does not use the traditional differential input pair , but use the nmos tube and the pmos tube parallel supplementary differential input pair to the structure , and uses the proportional current mirror technology to realize the constant transconductance of input stage . in the middle gain stage design , the current mirror load does not use the traditional standard cascode structure , but uses the low voltage , wide - swing casecode structure which is suitable to work in low voltage . when designing output stage , in order to enhance the efficiency , it uses the push - pull common source stage amplifier as the output stage , the output voltage swing basically reached rail - to - rail . the thesis changes the design of the traditional normal source based on the operational amplifier , uses the differential amplifier with current mirror load to design a normal current source . the normal current source provides the stable bias current and the bias voltage to the operational amplifier , so the stability of operational amplifier is guaranteed . the thesis uses the miller compensate technology with a adjusting zero resistance to compensate the operational amplifier
本论文对国内外的模拟低电压低功耗技术做了广泛的调查研究,分析了这些技术的工作原理和优缺点,在吸收这些技术成果基础上设计了一个1 . 5v低功耗轨至轨cmos运算放大器。在设计输入级时,为了使输入共模电压范围达到轨至轨,不是采用传统的差动输入结构,而是采用了nmos管和pmos管并联的互补差动输入对结构,并采用成比例的电流镜技术实现了输入级跨导的恒定;在中间增益级设计中,电流镜负载并不是采用传统的标准共源共栅结构,而是采用了适合在低压工作的低压宽摆幅共源共栅结构;在输出级设计时,为了提高效率,采用了推挽共源级放大器作为输出级,输出电压摆幅基本上达到了轨至轨;本论文改变传统基准源基于运放的设计,采用了带电流镜负载的差分放大器设计了一个基准电流源,给运放提供稳定的偏置电流和偏置电压,保证了运放的稳定性;并采用了带调零电阻的密勒补偿技术对运放进行频率补偿。
9.The other is the design of amplifier with constant trans - conductance ( gm ) rail - to - rail input stage . when common mode input voltage changes , it provides nearly constant - gm independent of input transistor operating region ( strong , moderate or weak inversion ) , and the quiet nods of the circuit for current addition and the output stage keep unchanged
当输入共模电压变化时,不管它的输入mos差分对管处于强反型区还是弱反型区,输入级的跨度保持不变,而且输入级后面的电流加法电路和输出级的静态工作点也不会随之改变。
Similar Words:
"rail-roadvehicle" English translation, "rail-ship interface" English translation, "rail-slitting mill" English translation, "rail-splitter" English translation, "rail-straightening machine" English translation, "rail-type hot bed" English translation, "rail-type launcher" English translation, "rail-type test installation" English translation, "rail-water terminal" English translation, "rail-web bond" English translation