| 1. | The first point we analyzed is the digital deconvolution with noise
第一是含噪声的数字反卷积。 |
| 2. | A new constrained deconvolution method and its application in multipath time - delay estimation
一种新的多径时延估计的约束反卷积方法 |
| 3. | Comparison of two kinds of linear algorithms in three - dimensional inverse convolution image technology
三维反卷积显微成像技术中两种线性算法的比较 |
| 4. | The results show that the frequency band extension technology using digital deconvolution has feasibility
研究结果说明数字反卷积展宽数字系统频带技术是可行的。 |
| 5. | Sori borne along the longitudinal veins and protected by the reflexed edges of the ultimate segments of pinnules
孢子囊沿能育叶裂片的纵脉两侧著生，并为裂片反卷的边缘所覆盖。 |
| 6. | Capsule ovoid , 6 - 8 mm long , more or less glandular hairy , coarsely tuberculate ; persistent calyx lobes often revolute and shrinking
蒴果卵圆形，长6 - 8毫米，多少被腺毛，有粗糙的小疣状凸起；宿存花萼裂片常反卷和皱缩。 |
| 7. | The influence of the detecting array on the spectrum signal is studied . a solution is put forward to correct the displacement error caused by width of the light activated element , when the sampling theorem is satisfied
提出了在满足采样定理的前提下，采用频域反卷积的方法来消除由像元宽度对光谱峰值定位造成的亚像元误差。 |
| 8. | The self - tuning white noise wiener estimators and information fusion self - tuning white noise wiener estimators are presented , and self - tuning wiener filter and wiener deconvolution filters for signals are also presented
提出自校正白噪声wiener估值器和信息融合自校正白噪声wiener估值器，以及信号自校正wiener滤波器和wiener反卷积滤波器。 |
| 9. | We discussed common methods of digital deconvolution and analyzed effects of noise on it . then , we simulated digital deconvolution filters and optimization criteria of filtration parameters . after that , we gave the application of them in the frequency band extension technique
首先，介绍了数字反卷积的常用方法及噪声对数字反卷积的影响；然后，研究了常用的数字反卷积滤波器及滤波参数的优化准则；最后，给出了数字反卷积在频带展宽技术中的应用。 |
| 10. | The results showed that the molten steel enters into the mould assembly in three flows of which the two move upward peripherally at the same time to form symmetrically two eddies at the upper part of the mould , while the other one moves downward peripherally and , eventually , goes out of the mould at the speed about the same
结果表明：钢液进入组合结晶器后分为三个流股，其中的两个流股对称地沿周向流动的同时向上反卷，在组合结晶器的上部形成两个对称的漩涡；另一个流股沿周向流动的同时向下流动，最终以几乎相等的流速流出结晶器。 |
