English translation for "受热面积"
|
- heating area
heating surface area
hot area
Related Translations:
受热递降: degradation on heating 局部受热: hot spottinghot-spotting 受热变形: temperature distortionthermal strain 受热器: heat receiverheat sinkthermium
- Example Sentences:
| 1. | Analyzing on the choice of smoke flow speed and the heated area ash and wear
浅析烟气流速的选择与受热面积灰和磨损 | | 2. | The difference of heated area between tubes is very small , so the thermal deviation mainly results from inhomogeneous endotherm and flux
但由于管子毛间的受热面积差异很小，过热器的热偏差主要由于吸热不均匀和流量不均匀造成。 | | 3. | Convex - concave shape : unique designed of convex - concave shape , which can strengthen and expand the heated measure . promote to absorb the light and heat energy . increase the radiating energy
在省油器表面形成许多凹凸面：使表面受热面积加大，促进吸收光能及热能，增加红外线放射能量。 | | 4. | The original design was intermediate vapor 42t / h , but the actual output is 30 - 35t / h , at the same time the temperature and pressure of the vapor are unstable , it affects the economic efficiency , the reason were the collecting dust on the heat area and serious corrision , they led to the decrease of the boiler load , and need stop to washing the dust , the article deals with the reform of the exhaust gas boiler , at the basic of the design condition , after thermo calculation , flute gas , resistence calculationand strenth calculation , the structure of the heat surface had been rearranged , then the proof calculation was done
原设计产中压蒸汽42吨时，但投运后只产30 - 35吨时，并且蒸汽温度和压力均不稳定，影响到经济效益。其原因是受热面积灰和腐蚀严重，影响传热使锅炉负荷下降，不能长时间运行，需停产清理积灰。本论文针对此余热锅炉的技术改造，在给定设计条件基础上，通过热力计算，烟气阻力计算和强度计算，对锅炉受热面结构重新布置，然后再作校核计算。 | | 5. | In this paper , a method for the on - line monitoring of fouling and slagging on utility boiler heat surfaces is put forward , and the basic principle of which is stated . on the basis of the method , a suit of on - line monitoring system of fouling and slagging is developed to guide and optimize the process of sootblowing
本文以燃煤机组为研究对象，提出了一套适用于电站煤粉锅炉的受热面积灰、结渣监测方法，阐述了监测方法的基本原理，并在此基础上开发了一套积灰、结渣在线监测系统来指导和优化吹灰过程。 | | 6. | Abstract : based on the analysis of influence of tubular rib construction on heat transfer area on steel blank and heat transfer space in furnace , a t - shape support system for tubular rib is presented , by which the construction of wholly overhead furnace hearth can be realized for large and medium scale continuous reheating furnaces , making furnace gases to come into full contact with steel blank , raising space utilization ratio of furnace chamber and improving heat exchange
文摘:分析了炉筋管结构形式对传热空间、坯料受热面积的影响；提出采用t形支撑技术优化炉筋管，可实现大、中型连续加热炉的全架空炉底，使炉气与坯料表面充分接触，提高炉膛空间利用率，可较大幅度提高炉膛热交换。 | | 7. | In this paper , the main work is that developing a suit of on - line monitoring system of fouling on the low - temperature convection surface and local slagging on water wall surface , to guide and optimize the progress of sootblowing , on base of the successfully developed monitoring system of fouling on the high - temperature convection surface
本文主要工作是在已经开发成功的高温对流受热面积灰监测的基础上，开发低温对流受热面积灰在线监测以及水冷壁局部结渣在线监测，来指导和优化吹灰过程。 |
- Similar Words：
- "受热表面的传热率" English translation, "受热的" English translation, "受热递降" English translation, "受热面" English translation, "受热面回转式预热器" English translation, "受热面积灰" English translation, "受热面面积" English translation, "受热面形成的管状空间" English translation, "受热面蒸发率" English translation, "受热器" English translation
|
|
|
