| 1. | Study on coating of sic containing ti on the surface of carbon fiber
碳纤维表面含钛碳化硅涂层研究 |
| 2. | Continuous cooling transformation of deformed austenite in titanium high strength steel
含钛高强度钢变形奥氏体的连续冷却相变 |
| 3. | An experimental study on degradation of ortho - nitrophenol with titania - bearing blast furnace slag
含钛高炉渣光催化降解邻硝基酚的实验研究 |
| 4. | The effects of batch annealing ( ba ) and continuous annealing ( ca ) on mechanical properties and hydrogen storage property of ultra - low - carbon enamelled steels were investigated
摘要研究了两种不同退火工艺罩式退火和连续退火工艺对含钛超低碳搪瓷钢板成型性能和贮氢性能的影响。 |
| 5. | By comprehensive rock - magnetic analyses of the hannuoba basalt in the zhangbei section , it has been shown that the main magnetic carriers of the twenty - one lava flows in this section are titano - magnetite , but the content of ti is relatively high in some samples
摘要通过新河口汉诺坝玄武岩的综合岩石磁学测定和分析，确定了该剖面21个熔岩流的磁性矿物是以钛磁铁矿为主，部分含钛较高。 |
| 6. | Abstract : the furnace body erosion of 2 blast furnace of pzh steel at the end of second compaign wassystematically investigated . the causes for furnace body erosion were analyzed . the features of furnace body erosion were clarified under conditions of intensification of smelting process . the mechanism of lining protection was further revealed with tio2 bearing burden , the technical measures which make the blast furnace high efficiency and long compaign were put forward
文摘:对攀钢2高炉第二代炉役炉体侵蚀作了系统地研究，分析了炉体侵蚀的原因，弄清了强化冶炼条件下攀钢高炉侵蚀的特点，进一步揭示了含钛物料的护炉机理，提出了实现攀钢高炉高效长寿的技术措施。 |
| 7. | The analyses of their microstructure showed that comparing with zl101 that contained no titanium , the trace amounts of titanium in alloys caused grain refining of al - l % si in zl101a prepared from electrolytic low content titanium aluminum alloy ( i . e . alti101a ) and zl101a prepared from electrolytic al - si - ti alloy ( i . e . ast101a ) , and the grain size distribution became more even , whereas the trace amounts of titanium have little influence on the size and shape of si particles in these alloys
微观组织分析结果表明，相对于不含钛的zl101 ，微量的钛可以使电解低钛铝合金制备的zl101a ( alti101a )和电解铝硅钛合金制备的zl101a ( ast101a )的( al )相的晶粒细化，晶粒大小分布均匀，但对它们的si粒子尺寸和形貌影响不大。 |
| 8. | In order to study the influence of the existence and adding ways of trace titanium on the fatigue properties of aluminum alloys , three important common - used standard cast alloys zl101a and zl101 were prepared with electrolytic low content titanium aluminum alloy , electrolytic al - si - ti alloy and pure aluminum respectively . the fatigue properties and relevant mechanical properties of these three cast alloys were tested and compared comprehensively
为研究铝合金中所含钛和电解加钛方式对铝合金疲劳性能的影响，分别利用电解低钛铝合金、电解铝硅钛合金和纯铝制备成三种铝硅系合金中重要的常用铸铝zl101a和zl101 ，测试其疲劳性能以及相关力学性能，并进行对比研究。 |
| 9. | The occurrence , mineral composition and constructure of titanium in solidified slags which are obtained from blast furnace slags via selective precipitating and growth have been studied , and the contribution of titanium among different mineral phases has been calculated by optical microscope , x - ray diffraction ( crd ) as well as scanning electron microscope ( sem )
本文采用光学显微镜、 x射线粉晶衍射、图象分析和扫描电镜等多种手段，研究了攀钢含钛高炉渣经选择性析出处理的凝渣中钛的赋存状态、矿物组成及结构，计算了钛在各矿物相中的分布，测定了原料中钛矿物的解离度，为钛的综合利用提供了科学依据。 |
| 10. | Abstract : the occurrence , mineral composition and constructure of titanium in solidified slags which are obtained from blast furnace slags via selective precipitating and growth have been studied , and the contribution of titanium among different mineral phases has been calculated by optical microscope , x - ray diffraction ( crd ) as well as scanning electron microscope ( sem )
文摘:本文采用光学显微镜、 x射线粉晶衍射、图象分析和扫描电镜等多种手段，研究了攀钢含钛高炉渣经选择性析出处理的凝渣中钛的赋存状态、矿物组成及结构，计算了钛在各矿物相中的分布，测定了原料中钛矿物的解离度，为钛的综合利用提供了科学依据。 |
