| 1. | typical cure temperatures range from 125 to 175℃.
典型的固化温度范围从125175。 |
| 2. | Shrinkage stress was found to increase linearly with cure temperature .
我们发现收缩应力随固化温度直线增加。 |
| 3. | Temperature and dielectric property of resin during rtm process
工艺中树脂固化温度与介电性能 |
| 4. | Testing concrete - method for temperature - matched curing of concrete specimens
混凝土试验.第130部分:混凝土试样固化温度对比方法 |
| 5. | Rate of cure and final strength will depend on the resistance time at the cure temperature
固化比率及最终固化强度取决于在固化温度条件下所持续的固化时间。 |
| 6. | Energetic materials for defense . physical - chemical analysis and properties . tnt solidifcation temperature . automatized method
国防用高能材料.物理-化学分析及特性. tnt固化温度.自动化方法 |
| 7. | After the electrophoresis , the magnets should be solidified on the low temperature firstly , then solidified in the high temperature
电泳后应先低温烘烤去除水分，然后高温固化；合适的固化温度是170左右，合适的固化时间为20min左右。 |
| 8. | Final cure temperature below 15 is not recommended for tank linings . if max . recoating interval is exceeded , please consult technical department for instructions
以下的固化温度不建议用于水箱内层。如果过了最大重涂间隔，施工前请咨询技术部门。 |
| 9. | The curing of the magnets always in the vacuum circumstance . as far as the mixture cohesion is concerned , the optimized curing temperature and time are 120 and 120min
所用粘结剂合适的固化温度是120 ，合适的固化时间是120min ，固化后磁体应该随炉冷却。 |
| 10. | Abstract : in this paper , a imidazole - salt was synthsised and was used with a polyphenol compound to modify the dicyandiamide curing epoxy resin system
文摘:本文针对双氰胺固化环氧树脂时的固化温度高，固化产物耐湿热性差的缺点，利用自行合成的咪唑盐和多羟基酚类化合物，对双氰胺固化体系进行了改进。 |
