| 1. | Topographical maps not only show planimetric position but also indicate relief by some method .
地形图不仅表示出平面位置，而且还通过某种方法显示地貌。 |
| 2. | Space of planimetric position
平面位置的空间 |
| 3. | Make the sketch for detail plane of scaffolding including access way . please see sketch no . - 1
5脚手架平面布置及上下通道平面位置见附图1 。 |
| 4. | Mapping accuracy to less than 2 pixels in xy - plane and 4 pixels in height can be achieved for plain operators
初步评估一般航测作业人员应可达两像元之平面位置较差，与四个像元之高程较差，足敷数位摄影测量实习。 |
| 5. | Non - destructive testing - acoustic emission - examination of metallic pressure equipment during proof testing - planar location of ae sources
无损检验.声学辐射.验收试验过程中金属压力设备的检查. ae源的平面位置 |
| 6. | Non - destructive testing - acoustic emission - examination of metallic pressure equipment during proof testing - planar location of ae sources
无损检验.声音辐射.在验证试验过程中金属压力设备的检验. ae源的平面位置 |
| 7. | We designed the beacons plane , used proper infrared ccd and designed real hardware circuite based on the dsp , which can be used to simulate and experiment on precision positioning algorithm by computer
设计了适当摄影测量算法的信标点平面，采用了红外波段的ccd ，以dsp为核心器件设计了信标点像平面位置坐标提取的硬件电路。 |
| 8. | The mark structure contains five parts : protective device , measure shaft , putright equipment , mark - bottom device and ground device , and gps measure pier functioning in elevation control and horizontal layout control is arranged as well
标体结构包括保护装置、引测装置、导正装置、标底装置、地面装置5大部分，并设gps测墩，兼有高程控制与平面位置控制的作用。 |
| 9. | Now the 2d precision of spatial points is very great , but because by usual correlation fitting method we can transfer gps ellipsoidal height into normal height of the local geoid is considered as mathematical curve plane , it is not conform the fact of mountainous districts so the precision of elevation is so small that it is not satisfied with the requirement of leveling
目前，地面点的平面位置确定精度已相当高，但高程精度始终未能达到水准测量的要求，因为将gps大地高转化为水准正常高的拟合推估方法是将局部大地水准面视为数学曲面，常常与实际情况差异较大(特别在西部山区差异更大) 。 |
| 10. | Sum - of - gradient - magnitude measure is chosen to adapt all images with different enlargement according to analysis of focusing measures ’ character . for 3d bond targets , it is explained that why focusing window should be placed accurately . efficiency of the whole system is ensured by analyzing shift of focal plane when enlargement ratio is changing
为了保证快速采集到键合器件的清晰图像,通过对调焦评价函数特征的分析,选择能够适应各个放大倍数显微图像的梯度作为系统的自动调焦评价函数;针对三维器件说明了调焦窗口正确放置的原则和必要性;分析了变倍过程中聚焦平面位置的变化规律,提高了自动调焦的效率。 |
