| 1. | Cycles - specification for dimensions of spoke nipples
自行车.第15部分:辐条螺纹接头尺寸规范 |
| 2. | Hydraulic fluid power - quick action couplings - dimensions and requirements
液压快换接头尺寸和要求 |
| 3. | Hydraulic fluid power ? quick - action couplings dimensions and requirements
液压快换接头尺寸和要求 |
| 4. | Mounting of rear shock absorbers for motorcycles and mopeds
摩托车和轻便摩托车后减震器安装接头尺寸 |
| 5. | Fibre cement pipes and fittings for sewers - part 2 : dimensions of joints
纤维水泥污水管和接头.第2部分:接头尺寸 |
| 6. | Air inlet air hose
进气接头尺寸pt |
| 7. | Specification for coupling dimensions for aero - engine refrigerant pressure replenishment connections
飞机发动机制冷剂压力灌注接头尺寸规范 |
| 8. | Insulator and conductor fittings for overhead power lines - dimensions of ball and socket couplings of string insulator units
架空电力导线绝缘和导线接头.第3部分:绝缘子组件球窝连接接头尺寸 |
| 9. | Specification for dimensions of electrical cable connectors for starter battery taper terminal posts cars and light commercial vehicles using positive earth system
起动蓄电池圆锥形接线端子的电缆接头尺寸 |
| 10. | Base on the analysis , the design of the pipe coupling is optimized by bringing forward a dimension scheme of the coupling which increase the connecting force and keep the maximal stress intensity within the safe scope
最后，通过模型，分析了管接头尺寸对管接头系统的强度的影响，并对管接头进行了优化设计，提出了一个能增大抱紧力，并保持最大应力强度在安全范围内的优化方案。 |
