| 1. | Ih = hold current - maximum current at which the device will not trip at 23 still air
维持电流，指在23度静止的空气环境中不会导致该设备‘跳闸’的最大电流。 |
| 2. | It = trip current - minimum current at which the device will always trip at 23 still air
维持电流，指在23度静止的空气环境中不会导致该设备‘跳闸’的最大电流。 |
| 3. | The iik absolute maximum rating specifies the maximum current that may be put through the ground - clamp diode
输入箝位电流iik规定了流过接地箝位二极管的最大电流的绝对最大额定值。 |
| 4. | Railway rolling stock . magneto - thermic microcircuit - breakers for maximum current for controls and auxiliaries circuits . dimension
铁路机车车辆.控制装置和辅助线路用最大电流热磁电机微电路断电器.尺寸 |
| 5. | Railway rolling stock . magneto - thermic microcircuit - breakers for maximum current for controls and auxiliaries circuits . generalities and tests
铁路车辆.控制和辅助线路用最大电流热磁电机微型电路断路器.一般原则和试验 |
| 6. | The maximum current allowed to flow through each tube is set by the drive - control settings , and is a service / factory level setting
流过每只管子的最大电流是由驱动控制电路的参数设定的，只有工厂或维修人员才可调整。 |
| 7. | This is the maximum output source or sink current that can flow safely into an output terminal of the device at voltages within the normal operating range
持续输出电流是指器件的输出端可以安全地注入或泵出的最大电流。 |
| 8. | This is the maximum current that can flow safely into an input terminal of the device at voltages above or below the normal operating range
在器件电压高于或低于正常工作电压原范围内，可以安全地流入器件输入端的最大电流。 |
| 9. | Railway rolling stock . magneto - thermic microcircuit - breakers for maximum current for controls and auxiliairies circuits . collection of particulfar leaves
铁路机车车辆.控制装置和辅助线路用最大电流热磁电机微型电路断电器.特殊簧片总成 |
| 10. | On the same winding , at most three taps can be made to form four transformer ratios , but the difference between maximum current and minimum current should not exceed one time ( for example : 150 - 200 - 250 - 300 / 5a )
在同一个绕组上最多可三次抽头，组成四变比，但最大电流与最小电流相差不能超过一倍（如： 150 - 200 - 250 - 300 / 5a ） 。 |
