English translation for "牵引特性"
|
- draw bar performance
tractive characteristics
Related Translations:
机械牵引: mechanical tractionpower traction 牵引伞: extraction parachute 牵引复位: replacement by tractiontraction reduction 牵引板: pull bladetowing plate 牵引角: angle of draftangle of drawangle of hitchangle of pullangle of tractiondraught angle 牵引中断: zugunterbrechung drive interruption
- Example Sentences:
| 1. | Analysis and modeling for the sub - harmonic load pull characteristics of the cdma power amplifier
功放电路副谐波负载牵引特性与建模研究 | | 2. | Abstract : the basic performance , features , structure , traction and braking characteristics of thefirst commercial emus in china are introduce d . parameters are also provided in detail
文摘:介绍了我国首列商用电动车组的基本性能、特点、结构、牵引特性及制动特性，提供了详细参数。 | | 3. | This paper discusses the influence of several parameters in heat release rate formula on the working process and proceeds with numerical simulation to the working process in part load condition according to the locomotive character
本文讨论了放热率中几个参数对工作过程的影响，并且按牵引特性对部分工况进行了计算。 | | 4. | Abstract : by making example of qcl03 bunker - cleaner , this paper proposes thequalitative analysis methods on the pulling performance of full hydraulic - driving vehicles whose power installation is explosion - proof electric motor and gains the practical performance curves of the real electric motor , then makes substitution of the formulas to make a quantitative analysis on the pulling performance
文摘:以qcl03清仓机为例，论述了以防爆电机为动力装置的全液压驱动车辆的牵引特性定性分析方法，在获得了电机的实际特性曲线后，将有关数据带入公式即可进行牵引特性的定量分析。 | | 5. | To save the resources and shorten the development cycle , these research methods were adopted , such as , using ug software to build the model , analyzing the removed snow ’ s track directly on the model , using adams to simulate the structure of avoiding obstacles , and using relative experience data to calculate the whole
( 5 )对原避障机构进行仿真分析,改进不合理之处,使铲刃避障轨迹为上凸曲线。 ( 6 )通过除雪车作业计算,分析前雪铲作业时整车的侧向稳定性、牵引特性及功率匹配特性,提出改进方案。 | | 6. | By analying the requirement of traction characteristics of rectifier in ac drive reciprocal power - fed test system , in this paper , the research on high power supply quality rectifer is conducted around topology and mathematical modeling , high power supply quality rectifer ' s control methods are summarized . predicted current control based on space vector pwm in two - phase stationary coordinates is proposed and used in this paper
本文分析了交流传动互馈试验系统牵引特性对整流电源的要求，对高供电品质整流电源的拓扑结构和数学模型进行了研究，总结了高品质整流电源的控制方法，阐述了本文采用的两相静止坐标系下基于空间矢量脉宽调制的预测电流控制方法。 | | 7. | This new technology changes from the traditional method by which the induced and compressor wheel separately are designed and produced to a new one by which the one - piece compressor is designed . on the basis of this new technology and the optimum blade profile , the performance of both the compressor and the turbocharger is largely improved . through the heating power calculation of the compressor , the analysis of the surge and the block of the compressor , the test - bed performance test of the turbocharger , the matching test of turbocharger and diesel engine , the propulsion test of the turbocharger on plateau condition , it is proved that the newly - designed compressor not only has high efficiency , but also improves the flow distribution in the high efficiency area so that the propulsion line can run through the high efficiency area
主要内容包括：提出一种全新的压气机叶轮技术和概念，这种技术将传统的导风轮和压气机分开设计、单独加工改为整体设计、整体加工的单体叶轮；从增压器与柴油机配机计算所得出的基本参数出发，通过对压气机进行热力计算，确定压气机的基本结构参数；再对叶型以及叶轮轮廓与叶轮罩壳的配合间隙进行优化，对新设计的压气机进行喘振和堵塞分析；通过增压器平台性能试验，验证了新设计的压气机的性能水平得到了较大的提高，达到了提高增压器的整体性能水平的目的；通过增压器与柴油机配机试验、以及增压器用于高原条件下的牵引试验，验证了新设计的压气机不但具有高效率，还改善了高效率区的流量分布，使牵引特性线贯穿高效率区。 | | 8. | It uses traditional methods to calculate and check the key parameters of crawlers " kinematics , dynamics and hydraulic drive systems and analyze and study the traction characteristics of hydraulic systems . then it also sets up the complete mathematical model of dynamic characteristics for the whole drive system , and carries out the simulation and analysis of dynamic characteristics through simulating model set up by matlab software
采用传统方法对推土机的运动学、动力学以及液压驱动系统的关键参数进行了分析计算和校核，并结合效率进行了驱动系统牵引特性的分析与研究，在此基础上建立了驱动系统的动态特性数学模型，利用matlab语言建立仿真模型，完成了驱动系统动态特性仿真分析。 |
- Similar Words：
- "牵引台" English translation, "牵引台车" English translation, "牵引毯状沉积" English translation, "牵引探雷车" English translation, "牵引套管" English translation, "牵引痛" English translation, "牵引头帽" English translation, "牵引推拿法" English translation, "牵引拖车" English translation, "牵引拖车侧卸设备" English translation
|
|
|
