Mobile
Log In Sign Up
Home > chinese-english > "磨损情况" in English

English translation for "磨损情况"

wear pattern
worn condition


Related Translations:
磨损:  wear and tear; abrasive wear; abrase; abrade; detrition; wear; scuff; wear-out; fray; battering; abrade wear; abrasion; attrition wear; defacement; excoriate; foreworn; wear down; wearing;
气缸磨损:  cylinder wear
轧辊磨损:  roll abrasionroll wear
角磨损:  corner wear
树脂磨损:  resin wearing
不磨损:  wearproof
刀具磨损:  cutting tool wearcutting-tool weartool wear
磁头磨损:  head wear
磨损试验:  abrasion testattrition testgrinding testreciprocal friction testwear testwearing test
严重磨损:  severe wear
Example Sentences:
1.Please check tyre for damage and wear
请检查轮胎的损坏和磨损情况
2.Please check for brake assembly wear
请检查刹车的磨损情况
3.Measure the master bushings for wear
测量主补心磨损情况
4.Testing the wear and effectiveness of metallic abrasives by centrifugal blasting
用离心喷砂法试验金属磨料的磨损情况和效果
5.The wearing of the boiler ' s low - temperature reheater pipes of xiaoshan power plant is introduced , the causes of the pipe wear are analyzed , and wear treatment measures are put forward
摘要介绍了萧山发电厂锅炉低温再热器管的磨损情况,分析了低温再热器管磨损的原因,提出磨损处理措施。
6.With the february purchase of the condition monitoring department of the oil and gas consultancy , production technology integrated as , abb norway acquired new oil field software technology called insight and sandview , in addition to three new employees
Abb挪威分公司获得了独特的监测技术,让石油公司可以计算由石油夹杂的泥沙造成的生产设备的磨损情况,这能使一个油田的生产价值每年增加数百万美元。
7.Secondly , choose the sample component , as different particle match of tungsten carbide and specifically heat treatment craftworks of solution and aging manufacture test piece , watch metallurgical structure of the test piece and do the tests of hardness and tension , at last do the abrasive wear test on the dynamic load abrasive wear test machine , analyze test datum , from the test data , conclusions are arrived that the hardnees of composite - alloy can be improved and wear - resistance be better by adding cr and other elements according to a given ratio
本文对rp中速磨煤机耐磨件进行了运行与磨损情况分析,研究、提出了制备磨辊和盘瓦复合合金成分配比;并对制作的试件进行了固溶、时效等特定的热处理工艺,观察试件金相组织,进行机械强度试验,最后做磨料磨损试验,对磨损失效机理进行了深入的研究分析,对其耐磨性能与低合金钢、高铬铸铁进行了对比。
8.Until now , there have been a few reports on the damage of the water pumps caused by sand and water cavitation . by use of the test loop for solid and liquid two phases , under the condition of 3 % head drop , the damage location and relative degree of the sand and water cavitaiton occurred on the impeller were tested and researched . the result was , them , compared with the results under the condition that water cavitation occurred and no cavitation but only wear occurred . the differencts were analyzed . the analysis result can be used as the basis of the further research and the improvement of the impeller shape
目前含沙水汽蚀对水泵损伤方面的报导甚少,本文利用固液两相流试验台,对离心泵闭式叶轮在含沙水汽蚀时( 3扬程下降点)的损伤部位和相对程度进行了试验研究,并将此结果与清水介质发生汽蚀时的损伤情况[ 13 ]及含沙水无汽蚀情况下的磨损情况[ 7 ]相比较,对其差异进行了分析,为今后进一步探讨叶轮损伤机理和叶型改进提供了实验依据。
9.Based on an experiment performed on the piston ring - cylinder bore wear tester , liquid - solid lubrication is investigated in this thesis . the wear of the samples under different lubrication conditions ( the solid concentrations are 0 % , 0 . 02 % and 0 . 1 % by weight ) are discussed . the variations of the surface topography , especially the statistical parameters and functional parameters are studied , and the reasons that cause the variations are analysed
本研究基于活塞环-缸套摩擦磨损台架实验研究了液-固二相流体润滑的问题,探讨了润滑油中不含固体颗粒、含有0 . 02和0 . 1纳米颗粒三种润滑状态下的磨损情况,并进一步研究了液-固二相流体润滑状态下试件表面形貌特性的变化,主要是统计参数和功能参数的变化,并探讨了引起变化的原因,为更深入的液-固二相流体润滑问题的研究以及表面形貌设计提供理论上的参考。
Similar Words:
"磨损期" English translation, "磨损期限" English translation, "磨损汽缸重镗" English translation, "磨损强度" English translation, "磨损侵蚀" English translation, "磨损曲线" English translation, "磨损圈" English translation, "磨损容差" English translation, "磨损容许量" English translation, "磨损砂" English translation