English translation for "缓冲电路"

buffer circuit
buffercircuit
cushion circuit

Related Translations:

缓冲瓶:  buffer bottledamping screensurge flask

缓冲电池组:  balancing batterybalancingbatterybuffer batteryby pass batterbypass battery

缓冲机构:  buffer gear

缓冲算法:  buffered algorithmbuffering algorithm

缓冲质量:  spring masses

缓冲计算机:  buffer computer

缓冲站:  buffer stationbuffered station

缓冲触发器:  buffer flip flopbuffered flip-flop

缓冲缸:  assistant cylinderbounce cylindercushion dashpot

缓冲地带:  bourreletbuffer stripbuffer zone

Example Sentences:

	1.	Simulation research and analysis on undeland buffer circuit 缓冲电路分析及仿真研究
	2.	Design of double forward passive lossless snubber circuit 双管正激无源无损缓冲电路的设计
	3.	To resolve this proplem . snubber circuit and soft switching technology are recommanded 为了解决这个问题，常用的两种方法是使用缓冲电路及软开关技术。
	4.	In addition , the appropriate parameters of snubber circuits and dead - times for igbt were worked out 另外还确定了igbt的缓冲电路参数、死区时间参数等。
	5.	The experiment result shows that the snubber can suppress the over voltage effectively at switch off and its dissipation is little 实验结果表明，该电路能够有效防止igbt关断过电压，缓冲电路损耗较小。
	6.	The hardware of the system is composed of a high - speed optical - isolator circuit , a first - in / first - out dual - port memory buffer circuit , a pci interface chip ql5032 , and a logic control circuit 系统的硬件部分是由高速光电隔离电路，双端口fifo存储缓冲电路， pci总线接口电路ql5032及逻辑控制电路等组成。
	7.	Therefore , the result can be applied to other power electronic devices such as transducer , svg , etc . lastly , apf ' s main circuit , snubber circuit and driver circuit were fixed , debugged , and improved in some aspects 最后，本文对有源电力滤波器的主电路、吸收缓冲电路、驱动电路进行了安装、调试，并做了一些改进。
	8.	Firstly , the summarize of the development and actuality of flyback converter is given , and different snubber circuits applied in the flyback converter are analyzed and compared 。 then the novel interleaved flyback topology is proposed 首先,对反激变换器的发展与现状做了全面的概述,比较了反激变换器各种缓冲电路的优缺点。
	9.	In the other , the paper analyses the working procedure and the working principle of the snubber circuit of the power supply in detail , and presents the basis and the method as to the choice of parameters of the snubber circuit 另外本文具体分析了该逆变电源中缓冲电路的工作过程和工作原理，说明了计算选取缓冲电路参数的依据和方法。
	10.	The push - pull mode switch power supply is chosen as the main circuit of the other voltages with pwm control circuit , over - current protection circuit , insulated drive circuit , mosfet buffer circuit and so on 采用高效的推挽式电路作为中低压电源的主电路，并以pwm控制电路、隔离式驱动电路、过流保护电路、 mosfet缓冲电路、软启动电路、稳压电路等作为辅助电路。

Similar Words：

"缓冲垫，减震器" English translation, "缓冲垫层" English translation, "缓冲垫环" English translation, "缓冲电池" English translation, "缓冲电池组" English translation, "缓冲电容器" English translation, "缓冲电压" English translation, "缓冲调度" English translation, "缓冲调节" English translation, "缓冲调整块" English translation