Mobile
Log In Sign Up
Home > chinese-english > "腐蚀电流" in English

English translation for "腐蚀电流"

corrosion current

Related Translations:
腐蚀动力学:  corrosion kinetics
抗腐蚀:  resistant to corrosion; slushing◇抗腐蚀掩膜 [半] etching mask
电镀腐蚀:  o electro-erosion
硫腐蚀:  sulfur corrosion
环境腐蚀:  environmental corrosion
腐蚀劳损:  corrosion fatigue
再腐蚀:  re-etching
烟气腐蚀:  flue gas corrosion
腐蚀损坏:  corrosion damagecorrosion troublescorrosive wearravage of corrosion
炉衬腐蚀:  blowing out of lines
Example Sentences:
1.Effects of diamond particles and their adding contents on the coating hardness , friction coefficient , wear resistance , corrosion current density and microstructures were studied
研究了金刚石粒子及其添加量对涂层硬度、摩擦因数、耐磨性能、腐蚀电流密度和微观组织的影响。
2.Poles - etching method is that the etching current caused by the external voltage is used to promote the intermediate ion product break away from the surface of substrate and keep the etching rate stable
电极腐蚀法是指在激光腐蚀的过程中,通过外加电压在溶液中形成腐蚀电流,促使中间离子产物脱离基片表面,使腐蚀持续稳定进行。
3.Though membrane time arises to the antiseptic efficiency by way of reducing and corroding the density of the electric current and increasing the resistance of polarising to corroding the influence of the electric potential by oneself not big in advance
虽然预膜时间对自腐蚀电位的影响不大,但通过降低腐蚀电流密度和增大极化电阻的方式也起到了防腐功效。
4.Scan speed ’ s affection for cable corrosion speed is studied , it is founded that the rapider the scanning rate , the bigger the measured corrosion current density , that is the quicker the corrosion rate , 8mv / s is the best scan speed . 2
研究了扫描速度对钢绞线腐蚀速度的影响;提出了扫描速度越大,钢绞线腐蚀电流密度也越大,腐蚀速度越快,其中8mv / s为最佳扫描速度。
5.The corrosion potential was the biggest and the corrosion current was the smallest one when the concentration of super - 3900 was 0 . 5 % ; the corrosion potential was increased with the addition of mps - dl , but the smallest corrosion current is under 0 . 01 % mps - dl . the rust time was the longest one when the concentration of super - 3900 was 0 . 5 % as well as mps - dl was 0 . 01 % . it was increased as a peak curve with al2o3 concentration in plating solution and ph value increased gradually with cathodic current density ; the corrosion weight
通过测量tafel曲线可知,在super - 3900浓度为0 . 5 % (相对于镀液的体积百分含量)时获得的镀层腐蚀电位最正,腐蚀电流密度最小;随着镀液中mps - dl含量的增加,获得的镀层的腐蚀电位逐渐正移,在浓度为0 . 01 % (相对于镀液的体积百分含量)时腐蚀电流密度最小。
6.Compared to bare steel strand , galvanized steel strand ’ s anti - corrosion is worse in 3 % nacl solution . 3 . the result of corrosion research in different ph value simulation acid rain show that bare steel strand has a low corrosion rate at ph = 4 , corrosion rate at ph = 2 and ph = 6 is larger ; epoxy coating steel strand ’ s corrosion current intensity decrease with ph value ’ s minish ; reverse to epoxy coating steel strand , galvanized steel
3 、模拟酸雨中腐蚀研究结果表明,在不同ph值的模拟酸雨中,全裸钢绞在ph = 4时腐蚀最慢, ph = 2时腐蚀最快, ph = 6时腐蚀速度居中;环氧钢绞线腐蚀电流密度随ph值的减小而减小;镀锌钢绞与环氧钢绞线刚好相反,腐蚀电流密度随ph值的减小而增加, ph值越小,腐蚀电流密度越大,越容易遭受腐蚀。
7.And takes the method of passing electricity in wet environment to carry on the reinforcement corrosion acceleration to the reinforced concrete , and uses the linear polarization method to carry on the test to the polarized resistance and corrosion current density of the steel bar flowed through by electricity at different time , analyzing the rule of the change of the reinforcement corrosion parameters , and test the chloride ion diffusion coefficient to evaluate the impermeability of the concrete
本文以不同水灰比、不同含气量、不同引气剂的钢筋混凝土为研究对象,采用湿通电法对钢筋混凝土进行加速锈蚀,同时采用线性极化法对不同通电时间的极化电阻和腐蚀电流密度进行测试,分析锈蚀参数的变化规律,并通过测定cl -扩散系数来评价其抗渗性。
8.The result indicates that when the air content of the concrete changes from 1 to 4 percent , the polarized resistance of the identical flow electricity time increases along with the increment of the air content , the corrosion current density reduces along with the increment of air content , the chloride ion diffusion coefficient reduces with the increment of air content ; when air content changes from 4 to 6 percent , the rule of the change of the polarized resistance and corrosion current density happens to be the opposite , the diffusion coefficient of the chloride ion increases along with the increment of air content ; when the air content is 4 percent , the rust - resisting property of concrete is best , and so is the impermeability of the concrete
试验结果表明,混凝土的含气量在1 . 9 % ~ 4 . 2 %变化时,极化电阻随含气量的增大而增大,腐蚀电流密度随含气量的增大而减小, cl -扩散系数随含气量的增大而减小;当含气量在4 . 2 % ~ 6 . 4 %变化时,极化电阻、腐蚀电流密度和cl -扩散系数的变化规律则相反;当含气量为4 . 2 %时,抗钢筋锈蚀性能最佳,抗渗性最好。 cl -扩散系数与钢筋锈蚀参数在一定程度上有着良好的相关性,抗渗性的结果较好地反映了混凝土中钢筋锈蚀的程度,可以用cl -扩散系数评价引气混凝土的抗钢筋锈蚀性能。
9.In acid copper sulphate solution , the nc copper has a more negative corrosion potential which is decreasing with reducing the grain size and diffusion impedance was only found in the as - prepared and as - annealed at 180 ? nc copper due to the diffusion within the pores and channels on the surface . both the tafel plots and eis study demonstrated that the nc copper exhibits a higher corrosion current and lower polarization resistance than its mc couterpart
在酸性硫酸铜溶液中,纳米晶铜的腐蚀电位比微米晶铜要负,并且随着晶粒尺寸的减小而降低。 eis研究表明,未退火的和180退火的纳米样品中发现了扩散阻抗,与表面孔洞和通道中的扩散有关。极化曲线外推法和电化学阻抗研究都表明纳米晶铜的腐蚀电流比微米晶铜高,而极化电阻要低。
10.The investigation indicates the electrochemical corrosion resistance characteristic of uranium surface has also been enhanced . the corrosion resistance of uranium with high carbon content may be lower than that of uranium with low carbon content . therefore we consider the carbon format ( carbide or free carbon ) may be the mainly reason of improving corrosion resistance
采用电化学方法,我们得到了表面经超临界co _ 2处理的铀试样在50 g / gcl ~ -中的阳极极化曲线和自腐蚀电流等抗蚀评价指标,结果表明经超临界co _ 2处理后的铀样品其抗化学介质腐蚀性能也有一定的提高。
Similar Words:
"腐蚀点" English translation, "腐蚀点;热点;高速飞机" English translation, "腐蚀电池" English translation, "腐蚀电化学实验" English translation, "腐蚀电极" English translation, "腐蚀电势" English translation, "腐蚀电位" English translation, "腐蚀电位势" English translation, "腐蚀电位仪" English translation, "腐蚀定向" English translation