English translation for "补偿量"

compensation dosage
complexity

Related Translations:

补偿:  compensate; make up; make up for; make it up to sb.; make sth. good; compensation; offset 短语和例子提供补偿 afford redress; 伤残补偿 disability compensation; 合理的补偿 fair compensation; 补偿某人损失 indemnify

Example Sentences:

	1.	The realization for rapid auto input of tools compensation to machine center 加工中心刀具补偿量自动输入的快速实现
	2.	Those who wish to trim or eliminate their emissions , but find it too expensive or difficult to do so , can thus buy the appropriate amount of offsets instead 意图削减或消除排放但认为所费过多的人可以购买适当的补偿量作为替代。
	3.	An universal equation , which can be directly used to compute the compensation resulted by the surface roughness , was deduced according to the flat - bottomed echo formula 根据大平底回波声压公式推导出了工件表面粗糙度和补偿量之间的关系，可直接通过计算得到表面粗糙度引起的衰减量。
	4.	The software can realize diagram paper design of over ten thousand kinds of specification of u - type expansion joints and the design range is dn25 - 1000mm , low pressure and middle pressure , with compensating value smaller than the 300mm 整个软件可完成u型、加强u型和型各种规格波纹管的设计；通径25 - 1000mm 、中低压下、补偿量小于300mm的u型膨胀节上万种产品的图纸设计。
	5.	According to the measured values of the joint angles and the end - effector positions , jacobian matrix is calculated , and errors between the desired and the measured positions of the end - effector are exported to the least square method to determine the compensation for the dimensional parameters of the robot 通过机器人关节角和末端手爪位置的测量数据，计算雅可比矩阵以及手爪位置理论值和实测值的误差，采用最小二乘法对机器人的尺寸参数进行补偿量的计算。
	6.	Compensation method of motion among the frames is also an important factor to affect the stability of image sequence , if the image sequence is compensated directly with the acquired movement vectors , it will feel the jumping of frame . in the paper , the parameter to compensate for the current image can be determined by average value filtering and have been applied to given motion model to stabilize the image stream . it can realize smoothly processing the image sequences to assure its stabilization 由于帧间运动的补偿方法是影响图像序列平稳性的一个重要因素，直接用运动矢量进行补偿，将会使图像产生跳跃感，本文提出采用均值滤波的方法来确定各帧的补偿量，实现了图像序列的帧间平滑衔接，提高了动态图像序列的平稳性。
	7.	At the same time , the method of disposal phase shift of ct by compensation is introduced . then the analysis and statistic of electrical power quality , the control scheme and compensating amount of capacitor for reactive power compensation are analyzed respectively . and in the paper , the control with a / y and the switch with ac contactor and solid state switch is valid measure not only for improving operate level economically and amending electrical power quality but also for avoiding of replacing switch frequently and decrease economic loss 然后对现有的算法进行了详细的分析、比较，筛选出既能满足硬件要求又可降低投资、保证精度、简化软件的方案，确定了准同步采样的方案，并通过对准同步采样误差的分析，提出了一种从45开始采样，从而提高精度的采样数据处理办法，同时，对于电流互感器相位漂移提出了一种补偿办法，接着对装置中电能质量分析与统计以及无功补偿中电容器的补偿量、投切原则也作了相应分析，其中对于无功补偿采用y混合接线，并利用交流接触器和固态开关共同投切电容，不但提高了经济运行水平、改善了电能质量，而且有效的避免了频繁更换开关，减少了经济损失；最后，设计了装置的硬件电路并绘制了相应的软件流程图。
	8.	Abstract : the design , manufacturing and measurement method of cam profiling are discussed in this paper by describing cam shaft grinding , fabrication of cam profiling , formation of contour of cam profiling , method of compensative fabrication of cam profiling , and measurement and evaluation of cam profiling 文摘:从凸轮轴磨床磨削工件凸轮、反靠凸轮靠模的过程，凸轮靠模轮廓曲线的形成，补偿反靠凸轮靠模的方法，标准凸轮轴的刮削及补偿量的确定，凸轮靠模的检测与评定等，论述了凸轮靠模的设计、制造与检测方法。
	9.	By analyzing the microstructure of as - cast alloys with different surplus of samarium added , the optimum surplus of samarium is decided . by comparing the microstructure of the alloys annealed for different time , the ideal and economical annealing time is confirmed . the microstructure and phase composition of alloys during the whole preparation of sm2fe17nx are analyzed using the scanning electron micrograph with energy - dispersive x - ray analysis and x - ray diffraction patterns 本论文首先就熔炼工艺参数对铸态组织微结构的影响进行了探讨，并制定出一套较为合适的熔炼工艺；通过对不同钐加入量的铸态组织微观结构的观察分析，确定了原料配置过程中钐的最佳补偿量；通过对采用不同退火时间的合金组织进行比较，确定了理想、经济的退火时间；同时还利用扫描电子显微图像和x射线衍射图谱，比较了整个制备过程中，试样微结构和相组成的变化情况。
	10.	First the paper use the different four network operating condition as the primary given conditions and set the 330 / 220kv transformer tap changer position in the standard position , adding the paralleled capacitor bank sets one by one into the network to change the amount of the input reactive power , thus obtained four sets of the 330kv and 220kv bus voltage and the active and reactive power losses changing curves 进而研究了在每一确定并联补偿电容器组投入量条件下，随联变调压档位变化而产生出的一组并联补偿量、母线电压与损耗的变化曲线。进而选出了陇南电网在四种选定电网运行方式下、有功损耗最小条件下的最优综合控制组合曲线。

Similar Words：

"补偿力矩" English translation, "补偿联动器" English translation, "补偿联轴节" English translation, "补偿链" English translation, "补偿链装置" English translation, "补偿量孔" English translation, "补偿量热器" English translation, "补偿疗法" English translation, "补偿流" English translation, "补偿流量" English translation