| 1. | Excess of hour angle increment
时角增量超差 |
| 2. | The error reason of electrometer in the calibration period to analyze and countermeasure
电能表检定周期内超差原因分析与对策 |
| 3. | It just seems to me that it would be a waste of talents and i doubt very many warlock use it
强化火焰石是超差的天赋我怀疑没有任何术士加它。 |
| 4. | The reason and prevention of four kinds defects including surface wrinkled skin ( carbon built - up ) , chock , blow hole , deformation , was introduced in this part of the article
本部分主要介绍表面皱皮(积碳) 、呛火、气孔、尺寸超差及变形等缺陷的产生原因和防止方法。 |
| 5. | A realistic and important question for manufacture and user of crank is how to settle the question jumping overproof of crank under the condition of crank without influence
在保证曲轴原有的组织和性能不受影响的情况下，解决曲轴跳动量超差问题，对曲轴生产厂家和使用单位来说是一个现实而重要的问题。 |
| 6. | Abstract : brief introduction and canalization of the vibration and noise outoftolerance problems arisen during the prototype test for series yax , and the suggestion for the prevention to them are given in t his paper
文摘:本文简要介绍了yax系列样机试制中遇到的振动、噪声超差问题，进行了原因分析，给出了拟采取的措施。 |
| 7. | During the shipbuilding in major shipyards worldwide , plenty of problems are generated out of shaft alignment , which results in the over - tolerance of main engine crank shaft , high temperature of bearing and excessive vibration
在船舶的建造过程中，世界各大船厂，都多次出现过轴系校中的问题，导致主机拐档差超差，轴承高温或造成振动过大等。 |
| 8. | Hardness is its most important capacities , whereas , because of hardness overproof caused by some reasons , during the practical quenching and temping process , low - alloy steel ca n ' t satisfy the need of producing technology
而硬度是其最主要的性能指标之一，在实际调质处理过程中，因各种原因而容易导致硬度超差，从而无法满足生产工艺的要求。 |
| 9. | 42crmo steel crank possess high proportion in the manufacture of crank . the research as a example of 42crmo steel crank , study feasibility and dependability of jumping measurement overproof alignment technology for crank
42crmo钢曲轴在我国曲轴生产中占有很大的比例，本项研究就是以42crmo钢曲轴为例，研究曲轴跳动量超差校直工艺的可行性和可靠性。 |
| 10. | Crank of internal combustion engine after every process and hot surface treatment will produce fairly deformation , that is jumping overproof . so alignment without destroy for its tissue and property is important factor which ensure operation of crank safely
内燃机曲轴在各加工工序及表面热处理后会产生一定的变形即跳动超差，对其组织和性能无破坏的校直是保证曲轴安全运行的重要因素。 |
