| 1. | Aerospace series . hard anodizing of aluminium alloys
航空航天系列.铝合金淬硬阳极极化 |
| 2. | Aerospace series . anodizing of titanium and titanium alloys
航天航空系列.钛及钛合金的阳极极化 |
| 3. | Method for making anodic polarization measurement for stainless steels
不锈钢阳极极化测量的方法 |
| 4. | Testing method for corrosion resistance of metallic biomaterials by anodic polarization measurement
用阳极极化测量法测定金属生物材料的耐腐蚀性的试验方法 |
| 5. | Standard reference test method for making potentiostatic and potentiodynamic anodic polarization measurements
作静电位标记和动电位阳极极化测量的基准测试方法 |
| 6. | A hydrogen - oxygen proton exchange membrane fuel cell , with a control system for pressure , temperature and humidity , was set up
摘要在组装的单体质子交换膜氢氧燃料电池系统上，用线性电位扫描法研究了不同电池温度和湿度下的阳极极化行为。 |
| 7. | The effect of borided layer at low temperature on wear resistance and brittleness of borided layer for steel 45 was studied by means of wear test , brittleness test and anode polarization measurement
通过磨损试验、脆性试验和阳极极化曲线的测试，研究了低温渗硼对钢渗硼层耐磨性、脆性和耐蚀性的影响。 |
| 8. | On the whole , the surface charge of chloroform is negative . thus , both the adsorption capacity of granular activated carbon and attractive or repulsive forces of charge influence the electrosorption of chloroform on granular activated carbon
阳极极化时，活性炭表面带正电荷，吸附点增加，吸附量与吸附速率提高；相反，阴极极化则活性炭表面的负电荷与氯仿异性相斥，吸附量减小。 |
| 9. | Adsorption isotherm and adsorption kinetics of granular activated carbon are measured in order to obtain specific information about the influence of the charge on the absorbability of chloroform . the influence of the bed potential on the adsorption equilibria shows a dependence on applied potential in electrolyte of approximately o . lmol / l ionic strength . with electrosorption from aqueous solution , 60 % enhancement of the concentration in one controlled potential is achievable
实验结果表明：在实验所加电场范围中，活性炭量与所加的电位之间存在一定的关系，从- 500mv ， - 300mv ， - 100mv ， 0mv ， 100mv ， 300mv到500mv ，活性炭吸附量随之逐渐提高，吸附速度加快，即阳极极化有利于活性炭吸附量提高，阴极极化则对活性炭吸附起抑制作用。 |
| 10. | The corrosion behavior of nanocrystalline ( nc ) copper bulks with various grain sizes prepared from igc ( inert gas condemsation ) and vacuum annealing in comparison with conventional microcrystalline ( mc ) copper ( as - rolled and electrolytic ) in acid copper sulphate solution and neutral solution containing chlorides under free corrosion conditions and anodic polarizations has been studied using potentiodynamic polarization , potentiometric analysis , cyclic voltammetry and electrochemical impedance spectroscopy . x - ray diffraction was used to estimate the grain size of the annealed nc copper . field emission gun scanning electron microscopy and x - ray energy - dispersive spectroscopy was used to characterize the surface morphology and analyze the surface composition after the polarization and potentiometric test of both nc and mc copper
本文研究了用igc (惰性气体蒸发凝聚原位温压法)制备并真空退火到不同晶粒尺寸的纳米晶铜和微米晶铜(冷轧紫铜、电解铜)在酸性硫酸铜溶液和中性含氯溶液中，在自腐蚀状态和阳极极化状态下的腐蚀性能。使用了动电势极化、电位测定、循环伏安法( cv )和电化学阻抗谱( eis )等方法。 x -射线衍射( xrd )的方法用来估算纳米晶铜晶粒尺寸。 |
