| 1. | Design and simulate of the single stage common emitter amplifier
单级阻容耦合晶体管放大器电路设计与仿真 |
| 2. | A resistor - condenser circuit at the input to the vertical oscillator
位于垂直振荡器输入端的一种阻容电路。 |
| 3. | Capacitance - resistance filter
阻容滤波器 |
| 4. | Cr selective amplifier
阻容式选频放大器 |
| 5. | Capacitive resistance coupling
阻容耦合 |
| 6. | Resistor - capacitor unit
阻容元件 |
| 7. | Easily changeable capacitor and resistor unit , to meet the testing requirements of other standards
可以非常方便地更换阻容套件，以满足不同标准的试验要求。 |
| 8. | High amplitude trigger pulse meets the power requirements of many thyristors connected in parallels . the voltage peak emerged in switching off inductance circuit is amortized by resistor and capacitor absorbed circuit
选取r = 54 ， c = 0 . 22 f的阻容缓冲吸收电路有效降低了快速晶闸管关断感性负载产生的过电压。 |
| 9. | In this dissertation , the signal integrity problem encountered in the high speed circuit design is analyzed theoretically . both pre - simulation and post - simulation instruct layouting pcb board and comfirming the values of the resistance and capacitance
本文对高速电路设计中遇到的信号完整性( si )问题作了理论性分析,并且通过布线前仿真和布线后仿真指导了pcb板的布局和布线,阻容值的选取等。 |
| 10. | Design the good - working signal processing circuit of the sensor , including the signal collecting circuit of three output polars the coupling circuit using capacitance and resistance the alternating amplify processing circuit and the stabilization voltage supply circuit
设计了性能良好的信号处理电路(包括锑化铟磁阻三端输出型信号采集电路、阻容耦合型交流滤波放大电路和稳压电源电路三个部分) 。 |
