| 1. | If this output does not switch between h and l anymore a hard-ware reset is produced and the processor is initialized again .
如这个输出不再在高电平和低电平间作切换，硬件复位就会产生，并将处理器再次初始化。 |
| 2. | Four way high rf output , output level 110dbuv
四路独立高电平输出，输出电平110dbuv |
| 3. | Indoor four way high output optical workstation : lhsk - 860b
室内型4路高电平输出光工作站： lhsk - 860b |
| 4. | 2 as module , depress yawp ; 3 adopt philips power add modul
3末级采用philips功率倍增模块高电平输出 |
| 5. | 8 test1 i low : for normal operation high : test mode
测试0口,输入低电平:正常工作;高电平为测试模式 |
| 6. | The bus is " idle " when both lines are high ( open - collector )
总线空闲时，两条线都是高电平(集电极开路) 。 |
| 7. | For this reason , a large static high - level output current is not required
因此，无需大静态高电平输出电流。 |
| 8. | 3 end adopt philips power doubler post module , high voltage output
3末级采用philips功率倍增模块高电平输出 |
| 9. | High level signal
高电平信号 |
| 10. | Ti ? the current into an input when a high - level voltage is applied to that input
一个高电平电压信号加到一个输入端时，流进该输入(端)的电流。 |
