| 1. | Antistatic design is good for desoldering the component
防静电设计有效地拆除组件。 |
| 2. | Overall design of soldering and smd / bga desoldering function
全面性维修设计,包括焊接及smd / bga拆焊双功能。 |
| 3. | Adopted non - touch desoldering technology avoids damage of circuit board
利用非接触式拆焊吸锡技术,使线路板免受损坏。 |
| 4. | Absorb gun has strong power for speedy desoldering and cleaning at the same time
吸锡枪吸力强,除锡快而干净,节省时间。 |
| 5. | Absorb gun adopted hot air for desoldering and strong power vacuum pump to clean up the tin efficient
吸锡枪利用热风加热及强力真空泵吸锡,除锡快净。 |
| 6. | A thermal relief is used on plane layers for thru - hole components to make soldering and desoldering easier
限热槽通常用于直插元件的内电层以利于焊接和拆焊。 |
| 7. | Widely applied in measurement of hot air of desoldering station and liquid of tin stove by k detector probe
利用k热电偶导线,可测量热风手柄的热风,或锡炉的锡液温度。 |
| 8. | Unique joint start function with 852d + desoldering station and 863e preheater has same step heating to protect pcb and bga
独设联机开启功能, 852d +拆焊机与863e预热台同步发热,保护pcb及bga 。 |
| 9. | Direct connect vias conduct so much heat away from the pin and into the plane that high temperature or long soldering time may be required to complete the joint - thermal damage could occur to both the board and the component from soldering or desoldering
在焊接时，直接连接的过孔会通过引脚把大量的热传导至内电层，因此完成焊接就需要很高的温度或者延长焊接时间，这就会导致在焊接或拆焊时发生电路板或元件的损坏。 |
| 10. | I talked to someone who did it , by taking apart and desoldering a usb to serial adapter to connect the kuro box s 3 . 3 volt , inverted , serial signals to another chip that used these - and soldered the missing resistor onto the kuro box s motherboard
我与某个曾经这样做的人聊过，他将机器拆开，把usb拆换为串行适配器来将kuro box的3 . 3伏电压串行信号反向连接到使用这些信号的另一个芯片并将缺少的电阻器焊接到kuro box的主板上。 |
