Chinese translation for "q轴"
|
- q axis
Related Translations:
q带: q bnadqbaq-bandquinacrine band q分类法: q sort methodq sort technique
- Example Sentences:
| 1. | According to the relationship of the angle of the maximum torque and the q axis , the reluctance torque for salient pmsm is made full use of and the sator current amplitude is reduced by a large percentage , so that the system robustness is greatly increased . at the speed loop , this paper presents a single value model algorithmic control strategy which is the simplied form of normal model algorithmic control and has less computation work than the latter , so the real - time performance is very good
对于嵌入式pmsm ，根据在电流幅值一定的条件下最大输出转矩与(为等效电流矢量和q轴之间的相位角)之间的关系，将磁阻转矩转换为输出转矩从而提高了输出转矩，改善了系统的控制性能；在速度环采用单步模型算法控制，其计算量比较少，提高了系统的实时性和鲁棒性。 | | 2. | For the bldcm which has a neither sinusoidal nor trapezoidal back - emf , that is , for a general shape back - emf bldcm , this dissertation proposes a novel id = 0 vector control method . by this method , the iq for a constant torque to produce is calculated through coordinate transformation , and the reference iq is tracked by vector control in the dq0 frame
对于实际反电动势波形既非正弦又非梯形波的无刷直流电动机，提出一种新型的任意波形反电动势无刷直流电动机的i _ d = 0矢量控制方法，通过坐标变换浙江大学博士学位佑文摘要求解产生恒定电磁转矩所需的q轴电流，并在dqo坐标系下通过矢量控制对q轴参考电流进行跟踪。 | | 3. | The stability of electric power system has been being focused for a long time toprevent a power system from losing synchronism after sudden fault ， researchers have done much work and got many accomplishments this paper applied the direct feedback linearization ( dfl ) technique on the power system ， a strong nonlinear system simulation results by matlab proved this method efficiency main works and results are as follows ： this paper compared some existing methods in excitation control ， fast valve control and coordinated control respectively , analyzed the developments and actuality of nonlinear control research in brief , illustrated why ransient stability could be greatly improved by using the fast valve control in chapter 3 ， indicated the importance of coordinated control farther this paper introduced the inverse system theory , based on which ， discussed the dfl theory , pointed out which had consistency with the inverse theory , expanded the dfl theory combined the idiographic model equations ， made which adapt to the model of a single machine - infinite bus power system this paper referenced abundance articles and educed a set of equations ， which could describe the dynamical process of excitation and fast valve control for synchronous generators in the equations ， there were several very important parameters of power system - - rotor angle ( ) ， rotor speed ( ) ， generator q axis voltage ( eq ) ， transient voltage ( e ' q ) ， active power ( pe ) ， mechanical input power ( pm ) ， valve opening ( ) ， generator terminal voltage ( vt ) ， based on the model ， nonlinear coordinated controller and terminal voltage optimal controller have been designed by using the expanded dfl theory and lq optimal control theory the simulation results showed that the controller could keep power system transiently stable under the effects of a symmetrical 3 - phase short circuit fault ， which achieved better postfault regulation compared with another two routine methods ， one is the proportion excitation controller and proportion fast valve controller , the other is the proportion excitation controller and the optimal fast valve controller , which could exert good performance when met 1ittle disturbance either
在介绍逆系统理论的基础上，详细介绍了dfl理论，通过比较阐明了dfl理论其本质是逆系统方法的一类，并结合具体课题推导出的模型方程将dfl理论进行了扩展，使之适应于电力系统这个强非线性对象。通过参考大量的书籍文献推导出一套实用的可将大型汽轮发电机励磁与汽门综合起来进行控制的模型方程，此模型方程涵盖了电力系统中特别引人注目的几个量- -转子角、转子转速、发电机q轴电势eq 、暂态电势e ' q 、有功功率pe 、机械功率pm 、汽门开度、机端电压vt ，在此基础上建立了实用的电力系统简化的数学模型，并将扩展的dfl理论应用于此模型系统，结合线性二次型最优控制理论设计出大型汽轮发电机的非线性综合控制器及机端电压最优控制器，通过仿真实验与采用常规的按电压偏差进行调节的比例式励磁控制器+汽门比例控制及采用常规的按电压偏差进行调节的比例式励磁调节器和基于二次型性能指标设计的最优快控汽门(考虑发电机的饱和因素)进行了对比，证实了采用此种控制器可以有效地提高电力系统的暂态稳定性，并且在电力系统遭受小干扰时同样具有良好的调节性能。 | | 4. | In the proposed technique the bemf waveform of bldcm need to be measured in advance at first , through computer simulation and frame transformation , the optimum q - axis current command is achieved . in order to minimize the torque ripple , the d and 0 - axis current command should be zero . furthermore , through reference frame transformation from dqo - axis to abc - axis , we can get the optimum current command in static abc reference frame
在这种控制方法中首先测量出电机的实际反电动势波形，然后通过计算机拟合和坐标变换，求得产生恒定电磁转矩所需的q轴电流，令i _ d ~ * = i _ 0 ~ * = 0 ，通过坐标变换，得到三相静止坐标系a - b - c下的参考电流i _ a ~ * , i _ b ~ * , i _ c ~ * ，利用电流滞环控制来产生pwm信号，由于这种控制方法中电流不会突变，从而可以较好的抑制转矩脉动。 |
- Similar Words：
- "q在j之后" Chinese translation, "q值" Chinese translation, "q值计" Chinese translation, "q值计,品质因数测量仪" Chinese translation, "q值因数" Chinese translation, "q转换开关" Chinese translation, "q装置" Chinese translation, "q资料" Chinese translation, "q字旗" Chinese translation, "r" Chinese translation
|
|
|
