| 1. | Temperature dependence of output voltage of insb hall sensor
霍尔传感器输出电压温度特性的研究 |
| 2. | The effect of temperature from 0 to 45 c to the sensor is also measured in the paper
同时测出了温度从0到45变化对传感器输出的影响。 |
| 3. | The conclusion that the temperature is the main effect factor is gotten from the examination
通过试验确定出温度是影响传感器输出的主要影响因素。 |
| 4. | In experiment output signals of sensor are amplified and processed , then entered into computer
测量过程中,传感器输出信号经过放大、处理后通过数据采集器输入专用计算机。 |
| 5. | Finally , the fiber optic weak magnetic sensor system is verified by experiments using the signal processing scheme
实验证明,传感器输出信号稳定性良好,不稳定度低于1 % ,系统噪声为3mv左右。 |
| 6. | However , the presence of measurement noises could cause certain error in system identification , thus decreasing the accuracy of the measurement
利用小波分析的方法可以对传感器输出信号进行滤波消噪。 |
| 7. | The experimental results which give the relation curve between the sensor output signal and the temperature variation confirm that this method is effective
通过实验，给出了传感器输出信号与温度变化的关系曲线，实验结果表明了该测量方法的可行性。 |
| 8. | The millivolt signal outputted by temperature transducer is sent to plc through temperature transmitter ; it can get every temperature value by computer data processing
温度传感器输出的毫伏级信号经温度变送器输出给plc的模拟模块，经由计算机运算得到各处的温度值。 |
| 9. | For traditional simulation methods , which simulate the output of temperature sensor , measurement lag , fault and the environment noise of temperature sensors can ’ t be considered
采用电子模拟传感器输出信号的方法不能将温度传感器的测量滞后、故障以及使用现场的噪声等情况反映出来。 |
| 10. | Meanwhile , using smc and computer to dealing the real time dynamic to the out put signal makes this transducer system has parameter and the proofread function of measure the precision
同时利用单片机和微计算机对传感器输出信号进行实时动态处理,使本传感器系统具备了参数和测试精度的自校准功能。 |
