| 1. | If this output does not switch between h and l anymore a hard-ware reset is produced and the processor is initialized again .
如这个输出不再在高电平和低电平间作切换，硬件复位就会产生，并将处理器再次初始化。 |
| 2. | You can even enter voltage values directly in vpp , vrms , dbm , or
Dbm电压值或高低电平值 |
| 3. | 8 test1 i low : for normal operation high : test mode
测试0口,输入低电平:正常工作;高电平为测试模式 |
| 4. | See iols static low - level output current for further information
详细信息，参见iols静态低电平输出电流。 |
| 5. | For this reason , a large static low - level output current is not required
因此，无需大静态低电平输出电流。 |
| 6. | Common low impedance connection points are signal low and guard
常见的低阻抗连接点为信号低电平和保护线路。 |
| 7. | Low - level inductance measurement for electrical contacts of electrical connectors
电连接器的电触点的低电平电感测量 |
| 8. | Ti ? the current that an external driver must sink to switch this node from high to low
一个外部驱动器必须吸收节点由高电平转为低电平的电流。 |
| 9. | Ti ? the current out of an input when a low - level voltage is applied to that input
一个低电平电压信号加到一个输入端时，流进该输入(端)的电流。 |
| 10. | Ti ? the current that an external driver must source to switch this node from low to high
一个外部驱动器必须吸收节点由低电平转为高电平的电流。 |
