Chinese translation for "充电电压"

charging vlotage
charging voltage

Related Translations:

充电发电机:  charging dynamocharging generator

充电过程:  charging processprocess of charging

充电电阻:  charge resistancecharging resistance

充电额:  charge capacity

正充电:  at modest chargesbe on charge

充电电源:  charge power supply

峰值充电:  peak charging

充电速率:  charge rate

充电过度:  overchargesurcharge

浮动充电:  float chargefloating charge

Example Sentences:

	1.	The effect of the charging voltage on the the life of storage battery 充电电压对蓄电池寿命的影响研究
	2.	The action of electrostatic on the atomization of fuel is investigated 研究了充电电压对燃料雾化特性的影响。
	3.	By recharging voltage recharge current vary , and as for the recharge gradually increases , not because of battery heating period and declined slightly 充电电压因充电电流不同而异，并随充电的进行而逐渐上升，到未期因电池发热而略有下降。
	4.	If the charge voltage of current is too high and cause overload , the function of overload protection can cut off output power . it may resume automatic after release from overload 在充电过种中若充电电流太大或充电电压过高引起机器过载时，本机的过载保护会将输出断开，待过载解除后，自动恢复。
	5.	According to the simulated results , the parameters of loop making the influences on transformer ’ s output voltage are analyzed , and suited transformer ’ s parameters are selected depending on the analytic result 其次用pspice分析了脉冲功率系统各部分参数对传输线充电电压的影响,并根据分析结果合理地选择变压器参数。
	6.	The distributions of velocity vector , vorticity . turbulent kinetic energy and some other detailed flow information in the field are obtained . the influence of electric field on the flow field is discussed and gives a deep insight on it 3 、首次采用piv技术对荷电喷雾射流流场进行了测量，获得了整个流场的瞬时速度、湍能、涡量等信息分布图，研究了流场特性随充电电压的变化情况。
	7.	The processes and characters of synthesis reaction for ni / al and ti / al under the influence of high intensity of pulsating electric current are researched . the characters of organization and structure of products under different parameters such as charge voltage , charge capacitance , pulsating electric current , pulsating amounts and pulsating duration are summarized 对高密度脉冲电流下ni al 、 ti al的反应特点进行了分析，总结了在不同的充电电压、充电电容、脉冲电流、脉冲数量、脉冲持续时间等参数下，反应产物的组织与结构特点。
	8.	In order to overcome this problem , i bring forward the task that named “ intelligent patrol system among storage batteris of stand - alone pv power station based on dsp ” . this system can combine with the working stand - alone pv power station perfectly , and can patrol every storage battery of the storage battery group that used in pv station . if the voltge , current and temperature of one battery is not in good state , the system will give alarm in time . if one battery will be bad soon , the system will give alarm too 为了克服充放电控制器对单个蓄电池不能检测的缺点,特提出研究开发基于dsp的离网太阳能电站蓄电池智能巡检系统。该系统可与当前离网太阳能电站完美结合,完成对蓄电池组中每一块电池的循环检测,如果单个蓄电池充电电压、温度、充电电流出现异常,及时报警,以使蓄电池处于更好的工作状态,提高蓄电池使用寿命。
	9.	Aimed at some problems such as short spraying distance , electricity - leaking and reverse ionization among electrostatic nozzles existing in the country , a induction charging and pneumatic energy electrostatic nozzle was designed . the basic designing theories , structure and working process of this nozzles were theoretically specified in the paper . and then the atomization quality and charge performances of this nozzle and its affecting factors were studied by carrying out performance experiment and statistic analysis . result of the studies indicate : ( 1 ) some progress were made in solving the problems list above ; ( 2 ) from this nozzle , droplet were minute and uniform , and higher charge - mass ratio can be obtained under lower electrostatic voltage , thus the atomization quality and charge performance of this nozzle were both better ; ( 3 ) within the experiment extend , air pressure at 0 . 2mpa , electrostatic voltage at 2400v were the most suitable parameters for the nozzle ; ( 4 ) the regression equations for describing droplet size , intensity of spray current and charge - mass ratio of this nozzle obtained from the experiment data had higher forecast precision ; ( 5 ) cross - effect of all factors were not significant , the atomization quality and charge performance were relative dependency affected by the factors 诸试验因素中，充电电压和喷孔直径对雾滴荷质比均有极显著的影响；气体压力和液体流量对雾滴荷质比的影响均不显著；影响雾滴荷质比的主要因素依次为充电电压和喷孔直径; ( 8 )在300v 、 600v 、 1200y 、 1800y 、 2400v 、 3000v六种充电电压t ，雾滴荷质比先随充电电压的增加而增大， 2400v后荷质比减小，推测:对于所研制的喷头可能存在一个最佳充电电压; ( 9 )由充电电压和喷孔直径的不同搭配所得雾滴荷质比不同这一结果，可看出，较大充电电压需配备较大喷孔直径以增强雾滴荷电效果; ( 10 ) td3 . 6和td3 . 4两喷头的雾滴荷质比曲线趋于重合，说明喷孔直径大于沪3
	10.	The study of the effect of material properties and dimensions and loading currents on liner buckling , using a capacitor bank as a driver , indicates that the mode number for buckling increases with the ratio of radius to thickness of a liner , and the yield strength to plastic hardening modulus , but keeps invariable with the increase of loading current , and that the magnitude of buckling increases with the loading current 用电容器组脉冲发生器装置作为驱动源，设计4种不同材料、不同尺寸的金属套简，通过调节电容器组的充电电压得到不同的加载电流，研究材料及几何参数、加载脉冲特性对套简屈曲的影响；采用瞬态非线性有限元方法对实验结果进行了数值模拟。

Similar Words：

"充电电流降到过充电终止电流" Chinese translation, "充电电路" Chinese translation, "充电电器" Chinese translation, "充电电容" Chinese translation, "充电电容器" Chinese translation, "充电电源" Chinese translation, "充电电阻" Chinese translation, "充电电阻器" Chinese translation, "充电调压器" Chinese translation, "充电读数装置" Chinese translation