Chinese translation for "加热面积"

area of heating surface
heating area
heating surface area
heating-surface area
heatingsurface

Related Translations:

加热:  heat; warm; heat additive; heating; heat(ing) up; warming; warmup; warming-up 短语和例子把它放在火盆上加热 heat it over a brazier; 把熔炉加热到1,800度 heat the furnance to one thousand eight hundred degrees; 先

加热线:  heater wire

电子束加热:  electron beam heating

加热饭:  heater plate

放热加热:  exothermic heating

前缘加热:  leading edge heating

加热柜:  heating container

加热速度:  firing rateheat rateheating rateheating speedheating velocityrate of heating

加热凝结:  heat-set

声加热:  acoustic heating

Example Sentences:

	1.	The main roller is of direct - heating mode , which makes the effective heating area exceed 75 % and increases the energy utilization 直热式主辊筒，有效加热面积超过了75 % ，提高了能源的利用率。
	2.	The welding technology of francis turbine runners is optimized from the view of subsection welding and local heating by numerical simulation . the result shows that welding residual tensile stress appears in the weld and its area nearby , and peak stress appears in the dangerous area of blades after practising quondam welding technology ; welding residual tensile peak stress in the dangerous area of blades can be decreased by welding both ends earlier and then welding middle section later during subsection welding , and decreasing effect on welding residual stress of the subsection welding is related to the weld length of blade outlets and welding direction of each subsection ; decreasing effect on residual stress of the local heating is direct proportional to heating time , heating temperature , heating area , and inversely proportional to cooling area , and welding residual tensile peak stress in the dangerous area is decreasing trend earlier , and then increasing trend later with heated location increased 本文利用数值模拟手段对转轮的焊接工艺从分段焊和局部加热两个方面进行了优化,结果表明:采用普通工艺焊接时,叶片焊后残余拉应力出现在焊缝及其附近区域,并且在叶片出水边的熔合线附近(危险区域)出现了峰值;在采用优化的分段焊时,先焊两端后焊中间的方法可以降低叶片危险区域的焊接残余拉应力峰值,降低效果与叶片出水边焊段长度、焊缝各段的焊接方向有关;局部加热法降低转轮危险区域残余应力的效果主要与加热时间、加热温度以及加热面积成正比,与冷却面积成反比,并且危险区域的残余应力随加热区域的增大呈先降低后升高的趋势。

Similar Words：

"加热罗" Chinese translation, "加热免疫原" Chinese translation, "加热面" Chinese translation, "加热面；传热面" Chinese translation, "加热面的热输出" Chinese translation, "加热面加热表面" Chinese translation, "加热面效率" Chinese translation, "加热灭活的,热灭菌的" Chinese translation, "加热灭菌法" Chinese translation, "加热模压法" Chinese translation