| 1. | Dynamic balance test method for motor vehicle tyres
汽车轮胎动平衡试验方法 |
| 2. | The blades have passed the test of dynamic balance and static equilibrium
浆叶均通过静动平衡试验。 |
| 3. | Dynamic balance test should be carried out to the rotor of the turbocharger
涡轮增压器转子应进行动平衡试验。 |
| 4. | Analysis on vibration of turbine generator unit and test on dynamic balance of rotor
水轮发电机组振动分析及转子动平衡试验 |
| 5. | The blades have been passed the test of the dynamic and static balance testing machine
浆叶均通过静、动平衡试验机特殊试验。 |
| 6. | This paper summarizes the test method of dynamic balance , which could be used for reference in other similar projects
该机组动平衡试验方法可为其他电站类似机组提供参考。 |
| 7. | After several times of dynamic balance tests and modifications , the vibration and swing of generating units are controlled within the allowances
通过多次动平衡试验与校正，使机组的振动与摆度控制在规范允许的范围内。 |
| 8. | Influences on fatigue life and dynamic balance from metallographic structure image , fatigue experiments and dynamic balance experiments were also analyzed
从条码的微观组织、疲劳寿命试验、动平衡试验中分析了对刀具疲劳寿命和动平衡的影响。 |
| 9. | Model dcw light - spot vectormeter , designed to from a complete set with a dynamic balabcing tester , is served as a display meter for phases and ampiltudes of dynamic unbalancing quantites . the meter is composed of two sets of measuring mechanisms in moving coil system , and is also put to use lightspot indication as well as polar scale
Dcw型光点矢量表是供动平衡试验机配套作为动态不平衡量的相位和幅值的显示仪表，它是由2组磁电系测量机构组成并采用光点指示及极坐标标度。 |
| 10. | Secondly , based on the defects of the uptodate balancing machine which were employed in the motorcycle manufacture plants , this dissertation has presented a new method on the means of checking unbalance mass of the motorcycle single - cylinder engine crank - connecting rod mechanism . it has adopted the hard - bearing balancing machine as the prototype , utilized tow group of resistance sensors placed in vertical direction with one another to pick up the information which stand for the inertial force of the motor engine crank set when it is running
其次，通过对当前国内外曲柄连杆机构动平衡试验的现状及其存在问题的分析研究，提出了一种新的测试方法：在工作原理上采用硬支承型测力式动平衡机，在测量方法上应用互成90的两点测量来矢量合成任意一点旋转惯性力大小及方向，这也是其不同于以往试验机的最大之处。 |
