| 1. | Synthesis of carbon nanotubes from cobalt n - hexane in situ
正己烷原位合成碳纳米管 |
| 2. | Thermoelectric properties of ce , la yfe1 . 0co3 . 0sb12 compounds synthesized by solid state reaction and spark plasma sintering
12的放电等离子烧结原位合成及热电性能 |
| 3. | Effect of graphite addition on microstructure and mechanical properties of in situ synthesized titanium matrix composites
石墨添加对原位合成钛基复合材料微观结构与力学性能的影响 |
| 4. | Fabrication of in - situ synthesized and functionally gradient composite coating or components using laser direct fabrication technique is the future development direction
利用原位合成和基于快速原型的激光直接制造技术制备梯度功能表层或构件是将来的发展方向。 |
| 5. | Lean - burn engine is operated at air - fuel ( a / f ) ratios of 21 : 1 and above , in addition , ignition is delayed , as a result of these technique , the nox emissions are very low
同时，本研究也成功地运用了由原位合成技术制作的分子筛堇青石整体式分子筛催化器，去除稀燃nox排放。 |
| 6. | 2 . in order to improve the luminescence properties , cds nanoparticles entrapped in an acrylic acid - hydroxypropyl acrylate copolymer ( ac - hac ) network were synthesized by in - situ synthesis method
用原位合成法，以具有强配位能力的聚丙烯酸?丙烯酸羟丙酯( ac - hac )为基体在水溶液中合成了cds纳米微粒。 |
| 7. | The third is the formation of crosslinked silica network and micropores which can protect mpc molecules from colliding with each other and therefore suppress dimerization . in order to prepare composites with the least dimerizatio
基于原位合成的思路，应用紫外一可见吸收光谱( uv / vis ) 、红外光谱( ir ) 、元素分析等测试技术系统地研究 |
| 8. | With the increase of eu3 + concentration , however , the luminescence intensity of the eu3 + and dbm co - doped vtes gels and mtes gels decreased gradually , which indicated that it is difficult to in - situ synthesize the rare earth complexes in the vtes and mtes gels
但在vtes凝胶和mtes凝胶基质中稀土有机配合物dbm ： eu ~ ( 3 + )原位合成的程度较小，其荧光强度随着掺杂稀土离子浓度的升高而降低。 |
| 9. | The study indicated that intensity of materials was enhanced because tic and zrc diffused in cu matrix , and counterworked the motion of dislocation . the cu - based composite materials that prepared in situ synthesis have more fine capability . the upper density was gained when pressing pressure was increasing , and sintering temperature was 800
研究表明， zrc 、 tic在铜基体中形成弥散强化，阻碍位错移动，提高材料的强度；用原位合成的cu - 50 tic粉末做原料制备的铜基复合材料具有相对优良的综合性能；提高压制压强，在800烧结可得到较高的致密度，而材料致密度的提高会提高材料的各项性能。 |
| 10. | The employ kaolinite / polyacrylamide intercalation compound as a raw material to in - situ synthesize sialon was test by the carbothermal reduction and simultaneous nitridation ( crsn ) technique . this work was supported by the national natural science foundation of china ( grant no . 40072014 ) , the natural science foundation of guangdong province ( grant no . 010496 ) and the foundation of state key laboratory for physical chemistry of solid surfaces in xiamen university ( grant no . 9911 )
研究工作得到国家自然科学基金项目《高岭石矿物表面功能基及其反应活性研究》 (项目批准号： 40072014 ) 、广东省自然科学基金项目《高岭石有机插层原位合成- sialon纳米材料》 (项目批准号： 010496 )和厦门大学固体表面物理化学国家重点实验室开放基金项目(项目批准号： 9911 )的资助。 |
