| 1. | Standard test method for determining the linearity of a photovoltaic device parameter with respect to a test parameter
根据试验参数测定光电器件参数线性度的标准试验方法 |
| 2. | The research of the effect of soi s - resurf included the impact of the geometry parameters and drift doping concentration on breakdown voltage and on - resistance
Soisingle - resurf效应研究。研究了soisingle - resurfldmos的器件参数对击穿电压和导通电阻的影响。 |
| 3. | Using this model the basic demultiplexing characteristics of edo are obtained . the results include the intensity distribution along output , spectral response , dispersion , etc
利用这个模型对设计好的器件参数进行了模场形状、频谱相应、色散等复用性能的模拟。 |
| 4. | From the result of the practice , this structure enhances the brightness of led effectively , improves the quality of the crystal and improves the performance of the device
并且从实验结果看，双层突变异质结有效提高发光亮度，改善了器件参数，晶体质量变好。 |
| 5. | Chapter 3 gives the topology of the main circuit on the base of meeting the request of this project , and also the parameters for the most important components in the circuit
第三章在对课题要求的基础上选择了主电路拓扑，并对主要的器件参数进行了计算与设置。 |
| 6. | Measurement of quartz crystal unit parameters by zero phase technique in a pi - network - part 2 : phase offset method for measurement of motional capacitance of quartz crystal units
用型网络的零相位法测量石英晶体器件参数.第2部分:石英晶体器件动态电容测量的相位补偿法 |
| 7. | The input electrical power at the given voltage is increased due to the larger emitting surface of the radial structure and the space - charge effects are also relatively small
用一维模型对折叠式谐振腔径向速调管振荡器进行了理论研究，分析了结构器件参数对束波相互作用的影响。 |
| 8. | Measurement of quartz crystal unit parameters - basic method for the measurement of two - terminal parameters of quartz crystal units up to 200 mhz by phase technique in a - network with compensation of the parallel capacitance c0
石英晶体器件参数的测定.第3部分:用与并联电容量co补偿相连的网络相位技术测量200mhz以下的石英器件的两极参数的基本方法 |
| 9. | Abstract : the paper presents the method with the encoder and decoder instructions , with the switch of bcd in possession of six input points to realize the externally setting up in the device parameter in plc of multibit data
文摘:本文提出应用数据编码指令和数据译码指令，用一位bcd码开关，占用六个输入点，实现多位数的plc器件参数的外部设定方法。 |
| 10. | To verify the results , the 2 . 5d karat code is used to simulate and analyze the non - linear interaction of the l - band coaxial bwo . much useful knowledge is obtained such as the growing of electromagnetic wave ,
为了便于器件参数的模拟优化,我们分别从结构参数、电子束参数、导引磁场等三个方面模拟分析了其对器件输出特性的影响,得到了许多有用的规律性知识。 |
