Chinese translation for "孔径尺寸"

aperture size
aperture skeleton
hole size

Related Translations:

实际孔径:  real aperture

孔径角:  angle of apertureangular apertureaperture angleopeing angleopening angle

孔径象:  aperture image

出口孔径:  exit aperture

孔径混合器:  aperture mixer

环状孔径:  annular aperturering aperture

有限孔径:  finite aperture

孔径均衡:  aperture equalization

多孔径:  aperture multipleaperture, multiple

孔径色:  aperture colour

Example Sentences:

	1.	08 . 02 test method for cell size of rigid cellular plastics 硬质泡沫塑料孔径尺寸测试方法
	2.	Specification for hole sizes for solid rivets 实心铆钉孔径尺寸规范
	3.	Absolute pore size 绝对孔径尺寸
	4.	Guide to the choice of aperture size and wire diameter combinations for industrial wire screens and woven wire cloth - general 工业用金属丝网筛和金属丝编织筛布的孔径尺寸和线径的组合选择指南.第1部分:总则
	5.	Guide to the choice of aperture size and wire diameter combinations for industrial wire screens and woven wire cloth - preferred combinations for woven wire cloth 工业用金属丝网筛和金属丝编织筛布的孔径尺寸和线径的组合选择指南.第2部分:金属丝编织筛布的优选组合
	6.	The seams of the internal threads are eliminated by the reverse rotation while producing few chips ， and uniform threads diameter is achieved even though the hole diameter is uneven 正转时挤压出内螺纹，逆转时切去内径部的缝隙(有微量碎屑排出) ，从而完成加工。下孔径尺寸即使零乱，也可以做出内径尺寸均一的螺纹。
	7.	Porous anodic alumina formed by electrochemical oxidation has a fine structure with a nanohole array . the size and density of the pore , and the porosity can be tailored by the anodizing conditions 用电化学方法制备的多孔阳极氧化铝(多孔铝)具有规则的纳米多孔阵列结构，通过改变阳极氧化条件，可以控制孔径尺寸、密度和空隙率。
	8.	To improve the fluorescent intensity of the dyes in alumina film , a series of experiments were conducted . to enlarge the diameter and extend the length of the pores , improve the porosity , and increase the concentration of dye solution can increase the quantity of dye in alumina film . therefore the fluorescent intensity of the dye in alumina film can be enhanced greatly 做了一系列实验考察了如何提高染料镶嵌膜的光致发光强度，发现通过改变多孔铝的孔径尺寸、空隙率、染料在溶液中的浓度等，以此增加镶嵌在多孔铝孔中的染料分子数量，可大幅度提高染料镶嵌膜的荧光强度。
	9.	The results show that samples sintered under the condition of 1600 @ and 4h30min - 4h50min using nanometer sic powder had plenty of micro cavities , whose sizes were in nanometer order and were about 80 ~ 90nm , and at the same time the microstructure of the samples were changed , if sintering time was over 4h30min , the signal of 4h - sic was very weak and even disappeared 结果显示对纳米碳化硅粉末在1600 ， 4h30min - 4h50min条件下烧结制备的样品具有大量的微孔，平均孔径尺寸达到纳米数量级，约为80 - 90nm 。样品的晶型也发生了转变， 1600 ， 4h30min以上时间烧结时， 4h - sic晶型信号很弱，基本消失。

Similar Words：

"孔径测光" Chinese translation, "孔径测井" Chinese translation, "孔径测量" Chinese translation, "孔径测量计" Chinese translation, "孔径测量显微镜" Chinese translation, "孔径磁约束" Chinese translation, "孔径错误" Chinese translation, "孔径大小" Chinese translation, "孔径待性" Chinese translation, "孔径单元面积" Chinese translation