| 1. | Designing of low - cost u - type bending die
型弯曲模设计 |
| 2. | The construction design of the bending die for improving the surface finish of parts
提高工件表面质量的弯曲模结构设计 |
| 3. | Influence of combined modes of piezoelectric ceramics on flexural vibration of a beam
压电陶瓷的组合结构对直梁弯曲模态的影响 |
| 4. | Flexural modulus gpa
弯曲模量gpa |
| 5. | Bottoming bending die
校正弯曲模 |
| 6. | Paper and board - testing of cores - determination of flexural modulus by the three - point method
纸和纸板.芯层试验.采用三点法对弯曲模量的测定 |
| 7. | Paper and board - testing of cores - determination of natural frequency and flexural modulus by experimental modal analysis
纸和纸板.芯层试验.通过试验模型分析法对自然频率和弯曲模量的测定 |
| 8. | The working modes were the ninth bending in - plane vibration modes , which had almost the same frequencies and realized movement of forward and backward using the same power supply
利用振子第9阶同频的两个正交的面内弯曲模态分别实现直线电机的正、反方向驱动。 |
| 9. | Prediction values of two braided composites agree well with their experimental values . influence of fiber volume content and braiding angle on specimens " strength was analyzed
从而论证了对于三维编织复合材料，测试弯曲模量和强度使用四点弯曲试验更合适。 |
| 10. | The problem that ommt resulted in pvc degraded was settled . but na - mmt in pvc / na - mmt composite was simply common filler , the space of the layers was 1 . 29nm
通过力学性能测试发现，在蒙脱土含量为7phr时，硬质pvc的缺口冲击强度最大提高了108 % ，弯曲模量也有所提高。 |
