Chinese translation for "成型温度"

forming temperature

Related Translations:

成型端:  forming ends of

冷成型:  cold forming process

气压成型:  air pressure formingblow moldinggas-pressure compactinggas-pressure compaction

成型轮:  forming wheel

挤出成型:  sqeezing

波形成型:  wave shaping

成型铣床:  moulderprofiler

离心成型:  centrifugal forming

成型纤维板:  moldboard

成型嘴:  forming nozzle

Example Sentences:

	1.	The optimal molding temperature and pressure of their composite are 140c and 7 . 3 mpa 麻纤维复合材料的最佳成型温度为140 ，成型压力7 . 3mpa 。
	2.	Both ramie and flax are hydrophilic fibers , their thermal stability is not pretty well 麻纤维素含有大量羟基，亲水性强，热稳定性较差，加工成型温度不宜过高。
	3.	The 4 factors , such as specific absorption of aggregate , dosage of fiber , dosage of cement and molding temperature , were assembled properly by orthogonal design method , the effects of the factors on the optimum proportion of asphalt were studied at the same time 采用正交试验方法分析集料吸水率、纤维用量、水泥掺量及成型温度这4个因素对沥青混合料最佳油石比的影响程度。
	4.	4 . the optimistic resin system and the effect of resin content on the targets performance are discussed by orthogonal experiments , based on which , the moulding process parameters such as temperature , pressure , cycle and post - cure temperature are designed optimistically 4 、通过正交试验确定了最佳树脂体系，确定了含胶量对靶板性能的影响，在选定基体材料基础上，通过正交试验分析，对复合材料成型工艺参数如：成型温度、成型压力、成型时间、后处理温度进行了优化设计，确定了体系的最佳成型工艺参数。
	5.	The approaches of enhancing the mechanical properties of ramie and flax composites were studied in this paper . the effects of surface pretreatment , fiber content , molding temperature and pressure as well as the effect of electron beam , microwave and ultrasonic wave on the mechanical properties of the composites were explored . the experimental results show that : 1 本文以苎麻、亚麻纤维为增强材料，线性低密度聚乙烯( lldpe )为基体，研制了两种麻纤维层压复合材料，研究了麻织物表面处理、纤维含量、成型温度、成型压力等对该复合材料力学性能的影响，得到了性能较为优异的麻纤维复合材料，探讨了复合材料的增强机理。

Similar Words：

"成型填料密封" Chinese translation, "成型条件" Chinese translation, "成型贴合强度" Chinese translation, "成型图" Chinese translation, "成型网片" Chinese translation, "成型温度范围" Chinese translation, "成型铣床" Chinese translation, "成型铣床 造型工 造型机 毛轧板" Chinese translation, "成型铣刀" Chinese translation, "成型铣削" Chinese translation