| 1. | Cause and control of wire breaking in drawing machine with converter
变频拉丝机拉拔断丝原因及控制 |
| 2. | Analysis and treatment of wire breakage in ls - wedm cutting
低速走丝电火花线切割加工断丝原因分析及处理 |
| 3. | Broken thread fancy yarn
断丝花式线 |
| 4. | Broken wire was a vital disadvantage for quality assurance of locked coil wire rope
摘要稳定、可靠地发现密封钢丝绳生产过程中出现的断丝对于其质量控制具有重要的意义。 |
| 5. | If the wire rope is rust or tear and wear , deduct the scrapping broken wires in table 16 according to table 18 , and then scrap the wire rope according to the results
2钢丝绳有锈蚀或磨损时，应将表16报废断丝数按表18折减，并按折减后的断丝数报废。 |
| 6. | In this paper , the stubble , rust of tie bars and destruction forms of anchorage device are considered equivalent to the loss of tie bars ’ sections which is the analysis parameter of this paper
本文将系杆的断丝、锈蚀及锚具等破坏形式等效为系杆截面的损失。 |
| 7. | A nondestructive system for monitoring broken wires in production line was designed , which based on the magnetic character of locked coil wire rope
根据密封钢丝绳的结构特点，采用漏磁检测技术，研制了一套断丝在线无损检测系统，能对密封钢丝绳生产过程中出现的断丝现象进行有效监测。 |
| 8. | The cutting experiments for difficult - to - machine materials have shown that the cutting rate can be increased much more , the surface quality improved and the probability of wire - breaking reduced
对难加工材料的切割实验表明：复合工艺能较大幅度地提高加工效率，改善表面质量，降低断丝概率。 |
| 9. | This dissertation put forward a method of eliminating noise and reconstituting broken wires signal and inquired the space - frequency range of the signal ripple resulted from tensile stress on the mfl signal curve
提出了去除干扰重组断丝信号的方法，分析了漏磁曲线上应力波纹的空间频率分量。 |
| 10. | The number of scrapped broken wires for hoisting hot metal or dangerous goods is taken as half of scrapped broken wires of general hoisting rope , including reduction for wear - and - tear on the surface of wire rope
3吊运炽热金属或危险品的钢丝绳的报废断丝数，取一般起重机钢丝绳报废断丝数的一半，其中包括钢丝表面磨蚀进行的折减。 |
