Chinese translation for "曲线控制"

curues

Example Sentences:

	1.	Curve model control parameter analysis of extended end plate connection 关系曲线控制参数的研究
	2.	When forestage dcs system or pid regulator happened fault , manipulator receiving failure signal immediately switch into manual control state , by keystroke controls operation signal output 可分别带有一路pid控制输出及一路变送输出。具有多种曲线控制输出功能：可实现曲线控制暂停清零步进等。
	3.	Firstly , a simplified model of the robot is established in solidworks , which is imported into the simulation software adams . and then the motion curves got from matlab are applied on joints control 在solidworks中建立机器人的简化模型,导入仿真软件adams中,再利用matlab中得到的运动曲线控制虚拟样机模型的关节运动。
	4.	In the process of degree reduction , two cases are considered respectively , one of which is about the case without conditions of endpoint interpolations , the other of which is about the case with conditions of endpoint interpolations of higher orders 两种方法均考虑了不带端点插值条件和具有端点高阶插值条件的情形，并给出了降阶said - ball曲线控制顶点的显示表示式。
	5.	This paper present an ideal and calculation method of the effective operating curve where cavitations characteristic is not change . based on the lifting - line and lifting - surface method , using effective operating curve to control the cavitation type and " new section " design method to extend the width of cavitation bucket . the width will almost increase 30 % than the common section 提出了保持剖面空泡特征不变的有效运转曲线的思想和确定方法，在升力线和升力面的基础上，应用有效运转曲线控制空泡类型，采用“新剖面”设计方法扩大空泡斗宽度，其空泡斗宽度比常规剖面增加近30左右。

Similar Words：

"曲线精度控制；曲线近似；曲线逼近" Chinese translation, "曲线井段钻进" Chinese translation, "曲线聚值集" Chinese translation, "曲线锯" Chinese translation, "曲线锯床" Chinese translation, "曲线控制点" Chinese translation, "曲线宽口接杆" Chinese translation, "曲线离散对数系统" Chinese translation, "曲线连接" Chinese translation, "曲线连续性" Chinese translation