| 1. | The optimal temperature in production of paecilomyces farinosus
粉质拟青霉菌生产中的最佳温度研究 |
| 2. | Optimise temperature and humidity
保持系统内部最佳温度及湿度 |
| 3. | Provides an optimum temperature for soldering pcb throughout reflowing operation
通过回流焊操作为焊接pcb提供最佳温度。 |
| 4. | And this immunoprobe can conveniently apply to the determination of practical sample
根据实验结果，选取30为最佳温度来进行实验。 |
| 5. | The optimal temperature for removing mineral deposits from stainless steel with an acid solution , for example , is 70 c
例如，从不锈钢上去除无机物的最佳温度为70 c 。 |
| 6. | Amount : per 100g for 10kg dry clothes . add more allordingly when wash heavy grease spots . better used in 85 water
使用量：对一般污物每10公斤加100克，重度污物适量增加，使用最佳温度为85以上。 |
| 7. | Frequency of piston and best temperature of glue are adjusted by operator according to the current production data so as to get the maximum glue current and reduce the waste of glue
操作者根据当前的生产数据适时调整活塞往复频率和胶水工作的最佳温度，减少胶水非生产性消耗。 |
| 8. | As compared with the pressure of carrier gas , the subatmospheric pressure is more favourable condition to atomize the hydride , so the atomization temperature was lower ( about 650 )
由于硒化氢的原子化是在负压下完成的，它将比常压或载气压力下更有利于氢化物的原子化，因而使硒化氢原子化的最佳温度降低。 |
| 9. | It was found that the thin films and target were of similar composition . the optimal deposition temperature was 150 - 200 and the tcr of thin films were strongly influenced by the target temperature
发现磁控溅射法可以沉积得到与靶材组分一致的锰铜薄膜，沉积的最佳温度为150 200 ’ c ，并且阴极靶的温度对薄膜tcr有很大的影响。 |
| 10. | With the directviewing analysis in the orthogonal experiments , the optimum process conditions of synthesis of pnp are gained . mol ratio ( cu / cl ) is the important affected factors . the optimum mol ratio is 1 . 08 - 1 . 1
采用正交实验的直观分析方法，得到了pnp合成的最佳工艺条件：官能团( cu cl )摩尔比为1 . 08 1 . 1 ，官能团摩尔比是影响得率的最重要因素；聚合反应的最佳温度是182 185 ；实验的最佳保温时间为90min 。 |
