| 1. | On any axis , frequency for 200 hz , max . causes error is 0 . 05 % g of range
在任意轴上，频率为200hz ，引起的最大误差为量程的0 . 05 % g |
| 2. | Astrometric limit : the maximum residual in the place of a reference star , specified in arc seconds
天文测量误差极限：参考星位置对应的最大误差，用角秒表示。 |
| 3. | The results demonstrate that the maximum difference between measured and calculated surface temperatures is less than 8 %
结果表明，数值计算结果与实验结果的最大误差小于8 % 。 |
| 4. | This method utilize one of the three linear arrays to pair the 1 - d doa which is estimated by the other two liner arrays respectively
该方法利用其中的一个直线阵来组合两个线阵分别估计的一维doa ，最大误差不超过0 . 6 ，改善了doa的估计性能。 |
| 5. | Experimental results show that the total measurement time is less than 0 . 1 second and the maximum error of voidage measurement is less than 6 %
实验结果表明摘要一在0 100测量范围内空隙率测量最大误差可小于6 ，得到一个空隙率测量值算法耗时小于0j秒。 |
| 6. | As the same time , temperature compensation , curve fitting , fuzzy theory and data amalgamation are applied to ensure the precision of measurement and advances the veracity
引入并采用了模糊理论用于微量水分测量，使测量最大误差不大于5 ，具有较高的精确度和复现性。 |
| 7. | Comparing the calculated results and the theoretical results , it can discover that the error is not out of the permitted range . then , the present method is efficiency and can be applied to engineering
计算解和理论解的误差分析表明，最大误差都在允许范围内，从而验证本方法是行之有效的，可以用于工程实际。 |
| 8. | Range of ambient temperature in which the force transducer may be operated with the acceptance of greater error limits , without the error limits being exceeded on subsequent use of the transducer within the nominal temperature range
在标准温度范围内，不超过最大误差范围，也不超过后续操作的误差范围的情况下，力转换器工作的环境温度的范围。 |
| 9. | Firstly by virtue of matrix differential algorithm to find the error expression of platform and than let the maximum error to be acted as the objective function , besides the parametric errors of each structure , position and posture of the platform were being arranged into the optimized variables as well
首先借助矩阵微分法求出平台误差表达式，将最大误差作为优化目标函数，除了各结构参数误差外，还将平台的位置和姿态列入优化变量。 |
| 10. | Theory support is provided in this paper when platform parameters are designed . a fir low - pass filter is designed for the experiment following the criterion of maximal - error - minimization . the order and the impulse response sequence of the filter are presented in this paper
本文运用最大误差最小准则的优化设计方法设计出本试验台要用到的低通滤波器,给出了所设计滤波器的阶数和滤波器单位响应序列,并画出了该序列的幅频响应特性曲线。 |
