| 1. | The maximum load on a bearing should always be smaller than the relief load in order to avoid scuffing .
为了避免划伤，轴承上的最大负荷应该总是小于其卸载负荷。 |
| 2. | Bracket supports ; dimensions and maximum loads
托架托座.尺寸和最大负荷 |
| 3. | What are the projected peak loads
计划的最大负荷是多少？ |
| 4. | Maximum load of the testing machine
试验机最大负荷 |
| 5. | Actually , just in short time can refrigeration systems work in the biggest burthen
实际上，制冷系统只是短时间工作在最大负荷。 |
| 6. | Finally , the three parts of annual peak load are united to make a uniform probability method
最后，联合年最大负荷各分量，建立统一的概率模型。 |
| 7. | Conclusion the changes of condylar shape induced by various operations directly influence its compressive mechanical properties and bone mineral content
3组髁突弹性极限负荷、最大负荷及刚度与骨密度之间均有显著或极显著意义的相关性，相关系数在0 . 862以上。 |
| 8. | There was marked and extremely marked linear positive relativity among condylar elastic - limit load , largest load , stiffness and bone density , in which all relative coefficients exceeded 0 . 862
其弹性极限负荷及位移、最大负荷及位移以正常组为最高，而刚度及骨矿含量则以切削组为最高，减径组各项指标均最低。 |
| 9. | This thesis presents a probability method to forecast annual peak load based on the research of the divided load model , and a practical system has been successfully formed according to the actual circumstance of henan province
本文在分解模型的基础上，提出年最大负荷概率分析与预测方法，并根据河南省的地区特点，成功地研制出一套适合河南省的年最大负荷概率分析与预测系统。 |
| 10. | Annual peak load is affected by multifarious factors , specially by local circumstance . at present , the methods of annual peak load forecasting are simple and low precision , and furthermore , none of these methods is considering of local circumstance
年最大负荷受多种因素影响，地区性特点强，目前的预测方法较为简单，分析精度不高，且没有针对地区特点的年最大负荷预测方法。 |
